0
To rebuild the front struts on a 1990 BMW 325i, start by safely lifting the vehicle and removing the front wheels. Then, detach the strut assembly by unbolting it from the steering knuckle and top mount. Disassemble the strut by compressing the coil spring and replacing the strut cartridge, seals, and any worn components. Finally, reassemble the strut, reinstall it in the vehicle, and ensure everything is properly torqued before lowering the car.
What else can I help you with?
How do you replace a water pump on a 1990 BMW 325i?
How do you replace a waterpump on a 1990 BMW 325i
Is it possible to change the engine between a 1990 525i and a 1990 325i?
The 1990 325i has a M20B25 motor. The earlier 1990 525i had the same motor, a M20B25, whereas the later 1990 525i had a M50B25.
Is 2006 BMW 325i front or rear wheel drive?
06 BMW 325i front or rear wheel drive?
How do you change rear breaks 1990 325i?
remove wheel
Are BMW 325i front wheel drive?
no, rear
Where is the speedometer sensor on 1990 BMW 325i?
plugs into the rear differential
Will the transmission from a 1990 BMW 325is fit a 1988 BMW 325i?
yes
Fuse box diagram for 1990 BMW 325I?
I have 1990 BMW 325 i and I can not close tboth doors.I need to locate where the fuses are
What is the correct tire pressure for 2003 BMW 325i?
Front/Rear 30/35
What type of transmission fluid should you use in the power steering reservior on a 1990 325i?
mercon III
What is the bolt pattern for a 1990 BMW 325i?
Offset +37mm Backspacing 5.51" Bolt Pattern 4x100
Trunk release 2001 BMW 325I?
It is down on the kick panel in front of the drivers door.
