To change the battery on a Peugeot 106, first ensure the vehicle is turned off and parked on a flat surface. Open the bonnet and locate the battery; then, disconnect the negative (-) terminal followed by the positive (+) terminal. Remove any securing brackets or clamps, take out the old battery, and place the new one in position. Finally, reconnect the positive terminal first, followed by the negative terminal, and ensure everything is securely fastened before closing the bonnet.
To change the dashboard light on a Peugeot 106, first, disconnect the battery to ensure safety. Remove the dashboard by unscrewing the necessary screws and gently pulling it away from the dashboard frame. Locate the burnt-out bulb holder, twist it to release, and replace the old bulb with a new one. Finally, reassemble the dashboard and reconnect the battery.
How do you change a shock on a Peugeot 106 gti
Go to a garage
Yes
80k
It means that the generator is not charging the battery, and needs to be looked at.
To change the rear window heater switch on a Peugeot 106, first disconnect the car battery to ensure safety. Remove the trim panel around the switch by gently prying it off, then unscrew the switch from its mounting. Disconnect the wiring harness from the back of the switch and replace it with the new switch. Reassemble the trim panel and reconnect the battery.
To change the horn on a Peugeot 106, start by disconnecting the battery to prevent any electrical issues. Locate the horn, which is typically found in the front of the vehicle near the grille. Remove the mounting screws and disconnect the wiring harness from the old horn. Install the new horn by reversing the process, ensuring it’s securely fastened and properly connected before reconnecting the battery.
well, I'm gussing it'sgonna have something to do with thescrew under the key, but I'm not sure past that I'm afraid!
To change the alternator on a Peugeot 106, first, disconnect the negative battery terminal to ensure safety. Remove the drive belt by loosening the tensioner, then disconnect the electrical connectors and bolts securing the alternator. Replace the old alternator with the new one, reconnect the electrical components, and reattach the drive belt. Finally, reconnect the battery terminal and start the engine to ensure proper functioning.
one behind glove-box, another in engine bay by battery
Change the bulb??