The manual for the 308SW is very misleading. I'll be generous and say it is perhaps a bad translation from the original french version but nevertheless could result in an expensive replacement of a broken rear light cluster.
The manual says to remove the two bolts holding the assembly in place. This part is correct. You'll need an Allen key attachment to your screwdriver for this.
Next it says to pivot the assembly out and shows a picture of the assembly being swiveled through 90 degrees. This is completely wrong. The unit does not pivot and trying to can result in snapping the plastic.
The unit is secured by a pin similar to the pin on a chair castor. You need to insert a small screwdriver at the top of the assembly and gently lever it backwards away from the vehicle whilst pulling backwards at the same time. Do not pivot or swivel the unit - it comes straight back. The pin will pop out of its hole and the unit pulls off.
Now you can unclip the wiring and then unclip the bulb support from the coloured section. Replace the bulb and reverse the procedure.
This cost me £20 at the local Peugeot dealer to watch the engineer do the work, but I'll know next time.
my rear left indicator and alarm light doesnt work, hoe do I change the bulb?.
How do you change the -driver side rear bulb Ford Taurus Station wagon turn indicator? The front indicator works but blinks really fast.
fitting rear bulb peugeot expert van
To change the rear indicator bulb in a Mazda 6, first, open the trunk and locate the rear light assembly. Remove the cover or access panel by unscrewing or unclipping it, then twist the bulb socket counterclockwise to release it. Pull out the old bulb and replace it with a new one, ensuring it is securely fitted. Finally, reassemble the light assembly and test the indicator to ensure it works properly.
what do you do if wingnut stuck when replacing a rear indicator bulb on a vw beetle
what bulb? if you need to change exterior front or rear or indicator? let me know.
For illustrated answer go to http://www.focusfanatics.com/howtos/rearlight/
To change the indicator bulb on a Citroën C4, first, ensure the vehicle is turned off and the keys are removed. Open the hood and locate the rear light assembly where the indicator bulb is housed. Twist the bulb holder counterclockwise to remove it, then pull out the old bulb and replace it with a new one, ensuring it's securely in place. Finally, reinsert the bulb holder and twist it clockwise to secure it back in the assembly.
You need the near pair of the rear lights and a screwdriver to unscrew the screws if you want to change the rear lights on a Peugeot 607.
Inside the bonnet at the rear of the indicator light fitting is a steel ring. This is a clip-in spring fitting. Once unclipped the indicator unit slides out. The bulb is attached by a simple push on fitting.
Pull the switch and change bulb in rear. 1 for night light and 2nd for fog light indicator.
Try looking through the small Owners Manual - I found great instructions on replacing the headlamps there. Also, which indicator bulbs are you asking about: front and/or rear??