To enable or reset the ABS sensor in a 2002 Volvo S80, you can start by disconnecting the vehicle's battery for about 15 minutes to clear any fault codes. After reconnecting the battery, use an OBD-II scanner to check for any ABS-related trouble codes and clear them if necessary. If the ABS light remains on, inspect the ABS sensor connections and wiring for any damage or corrosion, and consider replacing the sensor if issues persist. Always consult the vehicle's service manual for specific diagnostic procedures.
where is the crankshaft position sensor located on a 2002 Volvo S60 2.4 engine
where is the crankshaft position sensor located on a 2002 Volvo S60 2.4 engine
in mirror
It can not be reset, failed parts must be replaced.
My 2002 has it in the drivers side mirror.
It is located in the intake pipe between the MAF sensor and the throttle.
There isn't a reset, either the sensor, wiring, etc. is bad.
== ==
I have a 2001 Volvo S60 Turbo. My Volvo has two oxygen sensors. Both are in the exhaust system. The first is in the exhast pipe, close to the engine (it looks like a spark plug). The second one is in the catylitic converter. I had mine checked at Autozone (local auto parts store). I am having trouble disconnecting the electrical wire. In any event, if you replace the sensor, the code will have to be reset in order to extingish the check engine light. Autozone said that they can reset.
To reset the maintenance light on a 2002 Volvo V40, start by turning the ignition key to the "II" position without starting the engine. Press and hold the trip odometer reset button on the dashboard. While holding the button, turn the ignition off and then back to the "II" position again. Release the button, and the maintenance light should be reset.
no, you cannot reset the brake maintenance light until you get NEW BRAKE sensors. -Seven11
On a 2002 Volvo S80, the bank 1 sensor 2 O2 sensor is located downstream of the catalytic converter on the driver's side of the vehicle. It is positioned before the exhaust pipe exits the vehicle. To access it, you may need to lift the car and work from underneath, as it is not easily visible from the top.