0
What else can I help you with?
What is the firing order for a 1987 Volvo 240DL?
1 - 3 - 4 - 2 The distributor rotor turns CLOCKWISE The # 1 position on the distributor cap faces towards the engine front
Weres the crank sensor on a 96 2.4 pont engine?
The crank sensor is located at the left front of the engine
Where is the crank position sensor located on the engine of a bronco II with 2.9 engine?
it is on the front timing. near botton of crank pulley.
Where is crank sensor on 2006 wide glide?
the crank position sensor is located in front of the oil filter on the left side of the engine in front.
1994 s10 blazer crank position sensor?
The crank position sensor is on the front of the engine. It is behind the crank pulley on the left side.
Where do you replace the Crank Position Sensor in a 1993 Oldsmobile 88 Royale?
on the front of the motor under the front crank it has a plug going to the crank.
Where is the crank sensor on a 2004 Mercury Sable?
lower right front of the engine
Where is the Crank Sensor on a 2004 F250?
it will be on the lower front of the engine even with the crankshaft
What is a harmonizer?
a mass of balanced steel bolted onto the front end of the crank shaft for a smoother running engine
Where is the Location of crank sensor on 1998 Dodge Dually 3500?
12 valve engine: front above the crank pulley 24 valve engine: behind the starter.
Where is the crank shaft sensor on a 1994 buick lesabre?
under the crank pulley, right side of car under front of engine
Where is crank sensor located on 93 ford escort?
It's at the front of the engine. The engine sits sideways in the engine bay. The front is looking towards the engine from the right front fender. The crank sensor is at the 10 O'clock position of the crankshaft pulley. It is a rounded sensor pointing towards the teeth on the backside of the crank pulley. It picks up a magnetic signal from the crank pulley and turns it into about a 2 volt sending signal to the computer. Due to the low voltage it is good to check and clean all the wiring on the crank sensor with carburetor cleaner or alcohol.
