answersLogoWhite

0

Turn the ignition lock on and the radio on and wait. It can take up to a couple of hours depending on how many times the incorrect code has been inputed in the radio.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Why would a factory radio go off when i use a turn signal?

A factory radio will go off when you use a turn signal because of a bad connection, and you are advised to check the antenna lead, grounds, and the flasher.


Where is the turn signal flasher for a 2003 Monte Carlo?

Above the radio there is a button with red triangles on it. That is where the turn signal flasher is. You have to take the dash off to get to it.


What are the applications of squelch circuit in communications?

A squelch circuit turns off the audio input to the speaker when there is no radio signal being received. This stops the speaker from producing annoying noise when no radio signal is being received.


What is the advantage of AM radio?

The advantage of an AM radio is that the signal it gives off is more powerful than PM and travels further and can be used in any place in the world.


Why do cell phones sometimes ''cut off'' when you drive under a bridge or inside?

Metal and concrete stop the radio signal. Without a signal the call is dropped.


How do reflected radio waves affect the transmission of signals in a communication system?

Reflected radio waves can cause interference and signal degradation in a communication system. When radio waves bounce off surfaces and return to the receiver, they can create echoes and distort the original signal, leading to errors in transmission. This can result in poor signal quality and reduced communication reliability.


How do you get WAIT off the radio in a 2003 Mercedes ml320 been stuck on wait for almost 2 weeks?

Turn the ignition lock on and the radio on and wait. It can take up to a couple of hours depending on how many times the incorrect code has been inputed in the radio.You have to wait 2 weeks after you get highlites to get a perm


How do you get the aftermarket radio to cut off with the car?

Wire it to a power source that also cuts off when you turn the cars ignition off, like the signal lamps or something else.


What is the distance that a ham radio can travel?

The radio signal can travel to the moon, bounce off its face, and reach an operator on the other side of the world. You can even talk to the International Space Station!


How ems jammers work?

When you use an EMS or cell phone jammer a lower power radio signal is broadcast.this signal is capable of cutting off communication between the cell phone and its base tower.


Can you connect a two-way radio external speaker output to the stereo speakers so that it will override the stereo signal when you get a call?

Yes, absolutely you can. The difficulty is that the controller needed to do the job is not something that can be bought off the shelf. Here is one idea to make the system work: First, take the output from the communications radio and establish the signal characteristics. You may need an attenuator to reduce the voltage of the signal. Once the signal is at the right level, it will need to be connected to an input on the stereo. Additionally, a sensor that will detect an audio signal on the comms radio output or a sensor that detects a valid radio signal on the comms radio is needed. Use the sensor output to trigger a switch from the current input to the comms radio input on the stereo. As an alternative, the same sensor output can be used to switch the speaker signal from the stereo to the comms radio. You will need a separate amplifier to do this as well as a suitable signal switcher to select either of the two speaker signals. The solution is not particularly difficult for an engineer to produce but it is not a straightforward job either.


How is energy wasted by the radio?

Energy is wasted in radio transmissions due to inefficiencies in the amplification and transmission of the radio frequency signal. Radio antennas that are not properly tuned or positioned can also waste energy by emitting signals in unnecessary directions or by causing interference. Additionally, inefficient receivers can waste energy by not effectively converting the radio signal into usable information.