In a Fiat Punto - the level is under the dash, on the drivers side, near the footwell, simply pull / lift the bottom of the lever towards you.
If the level is slack - it points to a snapped bonnet release cable.
To open the bonnet in this situation, you'll need to get under the car.
I jacked up the car, placed it on a stand on the passenger side, and reached up underneath. I've videoed it - quick to do once you see it.
To open the bonnet on a Fiat Bravo, first ensure the vehicle is parked on a flat surface and the ignition is off. Inside the car, locate the bonnet release lever, usually found on the driver's side near the footwell. Pull the lever to release the initial catch, then move to the front of the car and slide the secondary safety catch (usually located under the center of the bonnet) to lift the bonnet fully. Finally, secure the bonnet with the prop rod if necessary.
the bonnet lever on a fiat brava is by the clutch pedel and has a red handle this may be the same on the bravo
There should be a cable hanging down from where the latch was. Just grip with a pair of pliers and give it a gentle pull. You will hear a click and then you can release and go to the front of the car and open the bonnet.If the level is slack - it points to a snapped bonnet release cable.To open the bonnet in this situation (on a Fiat Punto), you'll need to get under the car.I jacked up the car, placed it on a stand on the passenger side, and reached up underneath. I've videoed it - quick to do once you see it.http://bit.ly/Yh1dQ9TAG: Fiat Punto, Bonnet Cable, Snapped Bonnet Cable
AnswerThe Bonnet is called the Hood in the U.S. Pull the lever inside the car, on drivers side. Then release the hood (bonnet) with the lever located in the front grille.If the level is slack - it points to a snapped bonnet release cable.To open the bonnet in this situation (on a Fiat Punto), you'll need to get under the car.I jacked up the car, placed it on a stand on the passenger side, and reached up underneath. I've videoed it - quick to do once you see it.http://bit.ly/Yh1dQ9TAG: Fiat Punto, Bonnet Cable, Snapped Bonnet Cable
The latch release lever is on the driver's side on the floor next to the door. If the level is slack it points to a snapped bonnet release cable. To open the bonnet in this situation (on a Fiat Punto), you'll need to get under the car. Jack up the car, placed it on a stand on the passenger side, and reached up underneath. Watch the video: http://bit.ly/Yh1dQ9
Pull the handle on the drivers side to release it and then put your hand - palm up - through the gap at the front of bonnet in the middle so your fingers can lift the final release handle. If the gas struts are u/s then it will be very heavy to lift.If the level is slack - it points to a snapped bonnet release cable.To open the bonnet in this situation (on a Fiat Punto), you'll need to get under the car.I jacked up the car, placed it on a stand on the passenger side, and reached up underneath. I've videoed it - quick to do once you see it.Go to related links below.http://bit.ly/Yh1dQ9TAG: Fiat Punto, Bonnet Cable, Snapped Bonnet Cable
On a 2003 Fiat Ulysse, the bonnet catch is typically located inside the vehicle, near the driver's side. You can find it by pulling the lever located beneath the dashboard, usually to the left of the steering wheel. After pulling the lever, you might need to press the secondary catch on the front grille to fully open the bonnet.
Under the Bonnet.
open the bonnet, down near the front on the right hand side is a wire going into the gearbox, that's it
The bonnet release on a Fiat Scudo is typically located inside the vehicle, on the driver's side. You can usually find it near the lower left side of the dashboard, often near the door or under the steering wheel. It may be a lever or a pull handle that you need to pull to release the bonnet latch. After pulling the release, you may need to lift the bonnet slightly and find the safety catch to fully open it.
Under the Bonnet.
On the 1957 - 1974 version, the filler cap is on top of the tank, inside the front luggage compartment (bonnet). Release the bonnet from inside the car, open the bonnet by sliding the release catch in the gap first. The tank is facing you and the cap just unscrews.