There is a really thin horseshoe shaped circlip behind the winder handle . Use a screwdriver to gently lever the winder away from the panel and then use a small thin screwdriver to try and unhook the circlip . A bit awkward but trust me it will come off .
How to remove Window Winder Handles from VZ Holden Commodore
Normally its several screws on bottom panel and in the handles and surclip on the window winder handle if they have them. Then the whole panel should pull of and lift up over door opener
To refit the window winder on a Vauxhall Corsa, first, ensure that the window mechanism is properly aligned. Insert the winder handle onto the splined shaft, ensuring it fits snugly. If there’s a retaining clip, push it back into place to secure the handle. Finally, test the winder by turning it to ensure smooth operation.
Begin by removing the inside door panel. Remove the linkage from the window winder. Remove the window winder retaining bolts. The window winder will come off.
30a
To remove the window regulator from a Vauxhall Vectra, start by disconnecting the battery and removing the door panel to access the regulator. Carefully detach any electrical connectors and screws holding the regulator in place. Once unfastened, slide the regulator out from the window channel and pull it out of the door cavity. Finally, ensure to reassemble everything in reverse order after replacing or repairing the regulator.
Between the window winder and door card there should be a plastic ring about 8mm wide. Push this ring away from the end of the window winder. The windes should now slide off
To remove the window winder on a VW Lupo, first, ensure the window is fully closed. Use a flathead screwdriver to carefully pry off the plastic cover at the base of the winder handle. Once the cover is removed, you'll find a retaining clip or screw that secures the winder; remove it using the appropriate tool. Finally, gently pull the winder off the shaft to complete the removal.
remove the tiny C clip from under the winder 1.25 1996 N. don't rip it off like I did.
very carefully:) well done...you pillock
Just pull it!
To remove the window winder from a 1996 Hyundai Excel, first, use a flathead screwdriver to carefully pry off the decorative cover, if present. Next, locate the retaining clip or screw that holds the winder in place; remove it using the appropriate tool. Afterward, gently pull the winder off the window crank shaft. Be cautious not to damage the interior panel during this process.