remove the 2 screws that hold the console cover hinge
then inside the console pull up about 2" of the material from the bottom rear of the console - it should come up easily - there are two nuts there that must be removed.
then gently pry up the chrome plastic square trim that surrounds the shifter. Then gently pry up the outter plastic part around the shifter - there are two screws under there that must be removed.
Then it lifts out and the elect components have quick dicsonnects
Here is the link for images. You may be required to sign up to view the images.
http://www.benzworld.org/forums/r170-slk-class/1213966-removing-center-console-slk-230-a-2.html#post4562657
OR
http://ww2.justanswer.com/uploads/rmillerphd/2008-04-03_192844_mercedes14.pdf
How do you put the top down on a Mercedes slk230? there should be a button on the middle console that operate the convertible, that's how i let my convertible down on my 1999 slk kompressor
Yes
The M111.974 engine fitted to the 2003 R170 Mercedes-Benz SLK230 uses the Eaton M45 Roots-type supercharger.
To remove the headlamp assembly from a 2000 Mercedes SLK230, first disconnect the battery to ensure safety. Open the hood and locate the retaining screws or bolts securing the headlamp assembly, typically found at the top and side. Remove these fasteners, then gently pull the headlamp assembly forward to detach it from the vehicle. Finally, disconnect the wiring harness from the back of the assembly before fully removing it.
lube up the inside with wd-40 as much as possible then work it off by wiggling it from side to side
To remove the tension idler for the drive belt on a 2001 Mercedes SLK230, first ensure the engine is off and has cooled down. Locate the tensioner pulley and use a socket wrench to rotate the tensioner arm counterclockwise, which will relieve tension on the belt. Once the belt is loose, you can unbolt the tension idler from its mounting point and carefully remove it from the engine. Be sure to note the orientation for reinstallation.
The SLK230 Kompressor has a 2.3 L (2295 cc) 197 hp I4 supercharged engine.The SLK320 has a 3.2 L (3199 cc) 218 hp V6 engine.
u3fff
To read the dipstick on a 2000 SLK230 Mercedes, first ensure the engine is warm and turned off. Remove the dipstick, wipe it clean with a lint-free cloth, then reinsert it fully and remove it again to check the oil level. The oil level should be between the two marks or notches on the dipstick. If it’s below the minimum mark, add the appropriate oil type as specified in the owner’s manual.
On a 1998 Mercedes-Benz SLK230, the signal flasher is typically located under the dashboard, near the steering column. You may need to remove some paneling to access it. The flasher is often found in a relay box or as a standalone unit, and it can usually be identified by its cylindrical shape. Always consult the vehicle’s manual for specific details and diagrams for accurate identification.
There is no separate switch. It is unlocked when the car is unlocked.
Check the fuse, if power lock fuse is burnt, replace it.