it is located in the airbox under the air filter if i remember correctly (its been a while since i done one) pop the engine cover off, move the airbox and filter to the side and you should be able to see it, i believe the valve its self is held in by 2 10mm bolts but once again its been a while since i done it, its a bit stiff to get out sometimes but it will come with some persuasion!
located under a black plate in the center of your valve cover on top of engine. remove plate and you will see them there remove them and install new ones.
There's a steel plate with hex head screws located in the center of the valve cover. Remove the plate and the coil packs and plugs are located below
in enging compartment
Exhaust Gas Recirculation (ERG) recirculates a portion of an engine's exhaust as back to the engine cylinders. On a Renault scenic, the valve is located at the top center of the engine.
You turn the valve cap anti-clockwise!
Between the Alternator and Power steering there is stamped PVC on the plactic cover. After removing the plactic cover there is a steel plate. Remove the two screws in the plate and remove the plate. The PVC is located under this plate. Most GM vehicles of that vintage have a rubber grommet into the rocker cover and the PCV valve presses into that grommet. You can tell where the PCV valve is by following the vacuum line back to the throttle body.
the PCV valve should be located on top of the engine block, on the passenger side. there will be 2- 10mm bolts holding it down and a plate will be labled (PCV) on it. simply remove bolts, the spring and the PCV valve should be sitting right there.
there isn't a drain plug, you will have to remove the bottom hose
Turn off water supply to the valve. Remove the handle and trim plate. Unscrew and remove the valve cartridge. Install the new valve cartridge. Reassemble the handle and trim plate. Turn the water supply back on and test for leaks.
To remove a shower valve, you will need to turn off the water supply to the shower, remove the handle and trim plate, and then use a wrench to unscrew the valve from the piping. Be sure to follow any specific instructions for your particular type of valve.
Mine is on a 03 plate ,and it does not have an E.G.R Valve..
I need valve clearence renault clio 1.2 16v 2005. Can you help?