0
To remove the front bumper
* Remove the front indicators * Raise the front wheels off the ground and support the front of the car with axle stands * Looking under the front of the car you will see a cross-member which supports the front of the engine and the radiator etc. You should see the heads of three bolts at each end of the cross-member. The outer two bolts are the ones securing the front bumper, remove these and the bumper will slide forward and out.
What else can I help you with?
Will a vw golf mk2 bumper fit your mk3?
Nope
Will a mk2 Renault clio front bumper fit a mk3?
no i dont think it will they are totally different shape
How do you remove a vw golf mk2 manual gearbox?
How do u get the cable into the gear box out
How do you change a ignition barrel on a golf gti 1988?
See Q: How do you remove Steering wheel lock VW golf mk2?
Will a mk2 mondeo front bumper fit on a mk1 mondeo?
No it won't I'm afraid, they're just too different.
What is the price for a VW Golf MK2?
The price for a VW Golf MK2 city STROMer was at $34,000. (U.S.) up until its production was ceased in 1985. The VW Golf MK2 had a range of about 31 miles.
Would mk2 golf 16v gearbox fit a mk2 golf 8v?
yes i just put my 8v box on my 16v bolts straight on
Does mk2 golf 1.6 starter motor fit mk2 golf gti?
Yes, a starter motor from a 1.6 will fit a 1.8 and vice versa.
How do you remove steering wheel vw golf mk2?
You remove the horn button if its in the middle.. Or just remove the plastic in the middle of the steeringwheel. Then take a 24mm i think and unscrew the big nut. Then remove the wheel.
How do you fit a omp steering wheel boss to a mk2 Golf?
First you remove the steeringwheel...then you apply the boss with the big nut and washer. Done
How much does the 2012 VW Golf mk2 cost?
The best way to find the price of the Volkswagen Golf MK2 would be to contact a Volkswagen dealer. The price will certainly depend on the amenities that are desired.
How do you fit a mondeo mk2 front bumper?
Take the front grill out, The grille and headlights came off to get at screws at the front end, remove the three plastic plugs under the grill, and remove the splash guard under the bumper, jack up front of car and remove front wheels. Take the majority of inner wheel arch retaining bolts out and fold the front back out of the way (don't take it out completely) Remove the engine under-tray. Remove the two 10mm bolts fixing the bumper to the wing on each side (bit awkward to get to but not too bad). Remove the bumper, note you need to push the sides down first as there is a pin that locates them. Fit the new bumper.... bolts, plugs etc, line up and tighten. Refit everything else. Remove headlights and grill. grill has a torx bolt each side, and undo retaining clips on the headlights where it clips onto them each headlight has a torx bolt behind at the back under where the wires go in, and 1 torx bolt on the top, and one behind the grill. under where the grill was there is 2 or 3 black round push clips. Remove the engine under-tray
