You will need a 35 mm socket.
35mm
Identical bearing replacement procedure to a 307
use a slide hammer to remove the hub from the bearing. do this on the car. or remove complete knuckle and press hub out with a press
To remove the front wishbone on a Peugeot 106, first, ensure the vehicle is safely raised and supported. Remove the wheel, then disconnect the ball joint from the hub by removing the retaining nut and using a ball joint separator if necessary. Next, unbolt the wishbone from the chassis and any additional brackets or components attached to it. Finally, carefully extract the wishbone from its mounting points.
The hub is pressed in. Remove the knuckle with the hub and bearing in it and take it to local machine shop.
There are two tools needed to remove a front hub from a 2003 Frontier. These include a screwdriver and a cone wrench.Ê
The front hub takes a 35mm deep socket. (It is not necessary to remove the hub to change the rotor.)
# Raise and safely support the vehicle securely on jackstands. # Remove the brake caliper assembly. # Remove the front disc brake caliper anchor plate. # Remove the hub grease cap. # Remove the cotter pin. # Remove the spindle nut. # Remove the front wheel outer bearing retainer washer. # Remove the outer front wheel bearing. # Remove the hub grease cap gasket. # Remove the front disc brake hub and rotor. # Remove the wheel hub grease seal. # Remove the inner front wheel bearing.
To remove the front wheel hub on a 1992 Mitsubishi Stealth, start by safely lifting the vehicle and removing the front wheel. Next, disconnect the brake caliper and rotor to access the hub assembly. Remove the hub assembly retaining bolts, and then use a hub puller if necessary to detach the hub from the spindle. Finally, ensure all components are clean and inspect for wear before reassembly.
you cant
The torque settings for a Peugeot 406 front hub typically range from 80 to 100 Nm for the hub nut. It's essential to consult the specific service manual for your vehicle model and year, as specifications can vary. Always ensure to use a calibrated torque wrench for accurate measurements and follow proper tightening sequences if applicable.