To remove the fuel pump from a Fiat Punto, first, ensure the vehicle is off and disconnect the battery to prevent any electrical issues. Then, access the fuel pump by removing the rear seat or the access panel in the trunk. Detach the fuel lines and electrical connector from the pump, then unscrew the retaining ring or bolts holding the pump in place, and carefully lift it out. Always take necessary safety precautions, such as working in a well-ventilated area and avoiding sparks near fuel.
Remove tank, remove sending unit, replace pump, replace tank.
NO ! you must lower the tank down REMOVE it from under the van and replace the fuelpump ! REMOVE FUELPUMP ASSEMBLY ,FLOAT, GAUGE UNIT ALL ! has to be replaced in one unit ! approx. $ 270.00 DANNY COLEMAN
Remove the fuel tank to access the fuel pump assembly.
Use hammer.
if its on a punto gt is a lot of work.have to remove inlet manifold costs a lots for the job to be done in a garage.
open the door then drive into it with another car and it should remove it safely if not just use a hammer
fuelfilter is integrated in fuelpump assembly,part of fuelpump assembly
You will have to remove the air filter casing to get at them they are At the end of the HT leads from the coil
take window adjuster case of...remove the nut, is there a special tool to remove the mirror unit. There is a thread on the new mirror which goes into the door
To remove the front seat from a Fiat Punto, first, slide the seat all the way back to access the rear bolts. Use a socket wrench to remove the bolts securing the seat to the floor. Next, tilt the seat forward to access and remove the front bolts. Finally, disconnect any electrical connectors (if applicable) and carefully lift the seat out of the vehicle.
I'm afraid you cant remove the front head rests, very frustrating as I've brought new seat covers :o(
head off shims out buckets out and valve spring compressor remove collets and remove valves.