To remove the rear headrest on a 1995 Saab convertible, locate the release button or lever on the side of the headrest posts. Press or pull this mechanism while gently pulling the headrest upward. If it does not come off easily, check for any additional clips or fasteners that may be securing it in place. Once released, simply pull the headrest out of the seat.
To remove the rear seat headrest from a 1999 Jeep Grand Cherokee Laredo, first locate the release button on the headrest support poles. Press the release button while pulling the headrest upward to detach it. If the headrest doesn't come off easily, make sure the button is fully pressed, and try again. Once released, simply lift the headrest out of the seat.
unscrew bolts and take out.
Saw a video with a guy using a car jack to remove it. Looked like it was pretty easy.
It tips forward. remove headrest, and release to sprung catches at rear of seat, it then will tip forward
To remove the rear headrests on a 2005 Hyundai Santa Fe, locate the release buttons on the sides of the headrest posts. Press and hold these buttons while pulling the headrest upward to detach it from the seatback. If the headrest doesn't come off easily, ensure the buttons are firmly pressed and try again. Once removed, store the headrests safely or reinstall them as needed.
To remove the rear headrests on a 2001 Jeep Grand Cherokee Laredo, first, locate the release buttons on the sides of the headrest posts. Press the buttons while simultaneously pulling the headrest upward to detach it from the seat. If the headrests are stuck, you may need to adjust the seatback angle for easier access. Once released, simply pull the headrest out completely.
Removing the rear seat headrest can compromise passenger safety, as headrests are designed to reduce the risk of whiplash and other injuries during a collision. They also provide support for passengers' heads and necks. If you need to remove it for a specific reason, such as installing a child seat, ensure it is replaced correctly when not in use. Always consult your vehicle's manual for guidance on headrest usage and safety considerations.
On most cars theres a lever that you push and it can adjust hieght.But older cars no. 2012 Cruze has two types of headrest, the rear have a button release on BOTH posts in order to fully remove the headrest. The front headrest does not have a second button as it is not intended to be removed. HOWEVER ..... if you look closely at the side that does not have a button, there is a very small hole. Use a small allen wrench, slide it into the hole to release the locking mechanism. You must also hold in the button on the other side and pull up on the headrest all at the same time. The headrest will slide right out. Do not drive the vehicle with the headrest removed. I only needed to remove the headrest to install a seat cover.
Unzip back. Remove upholstry rings on the two bottom metal rods then slide the rear one half way out to fold it up. Remove rings holding middle metal rod. Push headrest halfway down. Slide a screwdriver up the front of the headrest post to keep the release lever from closing while removing the headrest. It is located behind the front seat foam. I have a 93 Lebaron GTC Conv
how much will it cost to replace rear bumper cover on 2003 93 saab
Take the bolts out remove bummper install new reinstall bolts
To reset the rear headrest on a 2005 CLK 500, first, ensure the vehicle is in the "On" position without starting the engine. Locate the headrest release button or lever, typically found on the side of the headrest. Press the button while pushing the headrest down to its lowest position, then pull it back up to the desired height. If the headrest is stuck, check for any obstructions or try manipulating it gently while pressing the release button.