answersLogoWhite

0

What else can I help you with?

Related Questions

Where is the brake light relay located in a 1991 Volvo 240?

The 1991 Volvo brake light relay switch is located beneath the drivers side dashboard. The brake light relay switch will be above the brake pedal.


Brake light won't work on 93 Volvo 940 wagon?

check the switch at the top of the brake peddle.


Installation of brake light switch for a 88 gmc serria?

how would remove brake light switch and replace on an 88 gmc


Where is the brake light switch located on a 1992 Volvo 240?

Above your left Knee when you are driving


What does fault code po504 Volvo s60?

Fault code P0504 for a Volvo S60 indicates a problem with the brake light switch circuit, specifically that the brake light switch signal is inconsistent or malfunctioning. This can lead to issues with the brake lights not functioning properly, which may affect vehicle safety and performance. It's advisable to inspect the brake light switch and its wiring for any faults or disconnections to resolve the issue.


How do you replace the brake light switch on a 1996 suburban?

Look under the dash on the 1996 suburban, and locate the brake light switch on the brake pedal arm. Remove the switch nut, and slide the switch out. Unplug the wires from the switch and install the new switch.


How do you replace the stop light switch in a 1998 chrysler Concorde?

brake light switch is mounted by the brake pedel remove lower panel above brake pedel and then you will see the switch should be able to turn the switch to replace


How to replace the brake light switch on Ford Explorer?

Try spraying the brake light switch with WD-40 first. If that doesn't fix the situation, then: . Remove the under-dash panel. . Locate the switch near the top of the brake pedal and disconnect the wiring harness. . Remove the switch retaining pin and the white nylon washer from the brake pedal pin, then slide the brake light switch and pushrod off far enough for the outer hole of the switch to clear the pin. . Slide the switch down to remove it.


How do you remove 1996 Nissan 300ZX brake light switch?

To remove the brake light switch on a 1996 Nissan 300ZX, first disconnect the negative battery terminal to prevent any electrical issues. Locate the brake light switch, which is typically found near the top of the brake pedal assembly. Unscrew the switch from its mounting position and disconnect the wiring harness. Finally, remove the switch from the bracket, and you can replace it with a new one if needed.


Where is brake light switch?

where is brake light switch


Where is the brake light switch located on a 1970 VW beatle?

The brake light switch on that bug would be found on the brake master cylinder. Remove the fuel tank to make access easier.


Why would the brake lights on a 1994 Volvo 940 wagon stop?

Check the bulbs, check the fuse, check the brake light switch, in that order.