answersLogoWhite

0

To remove the glove box in a Peugeot 406, first, open the glove box and locate the screws or clips securing it to the dashboard. Unscrew or unclip these fasteners, then gently pull the glove box towards you to disengage it from any remaining clips or hinges. Be cautious of any wiring connected to the glove box light, and disconnect it if necessary. Once free, the glove box can be completely removed from the dashboard.

User Avatar

AnswerBot

4d ago

What else can I help you with?

Related Questions

How would you remove a starter motor on a Peugeot 406 LX DT?

how do youremove a starter moto on a peugeot 406 please


How do you remove glovebox peugeot 207?

To remove the glovebox on a Peugeot 207, start by opening the glovebox and locating the screws securing it to the dashboard; usually, there are a couple of screws on the top and sides. Remove these screws using a suitable screwdriver. Next, gently pull the glovebox towards you while releasing any clips or tabs that hold it in place. Finally, disconnect any electrical connectors if your model has them, and the glovebox should come free.


How do you remove a fuel pump peugeot 406 2.0 lx petrol?

Slowly


How do you remove a driveshaft off of a peugeot 406?

This is a complex procedure, get a manual for this vehicle.


Where the hom on the Peugeot 406 2.0hdi?

WHERE THE HOM ON THE peugeot 406 2.0hdi out sade


Diagram of front suspension on Peugeot 406?

were will i get information for 1996 peugeot 406 petrol


How do you change the ignition coils on a Peugeot 406?

How do you change the ignition coil on a peugeot 406 coupe?


How do you replace a heater matrix on a Peugeot 406?

not an expensive job to do. part cost about £10 but apparently it is an awkard job as a part of the dash on passengers side needs removing to get in at it. how do you remove a heater motor from a peugeot 406 do you have to remove the full dashboard or just the glove compartment


Where is the AUX input in a Peugeot 308?

in the glovebox


How do you remove key stuck in ignition on peugeot 406 hdi?

To remove a key that is stuck in the ignition on a Peugeot 406 HDI, make sure that the car is in park. Then try to remove the key. If this does not work, spray the ignition mechanism with WD-40 after pulling out the key as far as possible. Then work the key in and out until it comes out.


When was the first Peugeot 406 car made?

The first Peugeot 406 was made in 1995. It was made by a the French Automaker Peugot to be a family vehicle. The 406 was last made in 2003 and then was replaced with the Peugeot 407 model.


Peugeot 406 Break How can you remove the panel for replacing the rear speakers?

Undo the 12mm nut from under the speaker in the boot.