0
To remove the alarm on a Golf 3 GTI with white wires, first ensure the vehicle's battery is disconnected for safety. Locate the alarm unit, usually found under the dashboard or near the fuse box, and identify the white wires associated with the alarm system. Carefully cut or disconnect these wires, making sure to insulate any exposed ends to prevent short circuits. Afterward, reconnect the battery and test the vehicle to ensure the alarm is fully disabled.
What else can I help you with?
How can you disable the backing alarm on an ezgo golf cart?
I'd just trace the wires from the alarm itself and disconnect them
Ok to use white spirits for golf gripping?
While white spirits can be used to remove old grip tape and residue from golf clubs, it is not recommended to use them for installing new golf grips. Using a gripping solvent specifically designed for golf grips will provide better adhesion and help extend the life of the grips.
Is it legal to remove pants in golf?
Not if its crazy golf lol
Where can you find the fuse for the factory alarm on a 1995 Golf GTI?
VW dealership
How do to reset mk3 golf gti alarm after flattened battery?
Open and close the bonnet !!
Where is the alarm siren on golf gti mk5?
under the drivers wheel arch liner, why ?
How disconnect the alarm on a 1994 golf?
On a 1994 VW Golf, the alarm can be turned off by disconnecting the smaller of two connectors coming from the Comfort Control Module. The Comfort Control Module is located behind the dashboard, to the left of the steering column.
What is the white plastic stand you put the golf ball on in golf?
Tee
Can you move and then replace a red stake during a round of golf?
Yes, you are allowed to do this. You are however, not allowed to remove white stakes as these mark the boundary of the course.
How do you reset the alarm system in a VW 1997 Golf GTI?
close the bonnet and then lock the doors
How much is it to replace an alarm horn on a Golf TDI 56 plate?
it`s about 69 dollars
How do you remove an alternator from a VW Golf?
1. Disconnect battery. 2. Remove the wires attached. 3. Remove the alternator (two bolts the top one is a 13mm and the bottom one is a 6mmhex). 4. put in new alternator in the opposite order. This is a simple procedure takes only about an hour at most.
