When your transmission is in park, it has a key release switch that can get corroded over time. I cleaned mine on my older Audi. You might be able to do that on yours.
If it is intermittent, run the lever from park to neutral, then back to park. Turn the key to start, but do not start the car. turn the key back to the off position. It should then pull out.
1996 rodeo- how to remove key from lock ignition?
Push the key into the ignition. To remove, push in, then turn towards you to remove the key. I do not know how to remove and replace the whole ignition assembly in case that was your real question.
how to remove key stuck in ignition switch in Chevy colbalt
To remove a key from the ignition of a 1992 Audi, first ensure the vehicle is in the "Off" position and the steering wheel is not locked. If the key won't turn or release, gently wiggle the steering wheel while trying to turn the key to the "Off" position. If the key is stuck due to a dead battery or ignition issue, consider checking the battery or consulting a professional locksmith for assistance. Always refer to the vehicle's manual for specific instructions related to your model.
To reset the Audi A3 key fob, first, insert the key into the ignition and turn it to the "On" position without starting the engine. Press and hold the unlock button on the key fob for about 10 seconds, then release it. Finally, turn the ignition off and remove the key; the fob should be reset and ready to use. If issues persist, consult your owner's manual or a dealership for assistance.
You have to have the key to that ignition to remove it. You can get a locksmith maybe. The dealership can make you a key from your vin# definitely good luck.
Find and remove the chime.
Remove the retaining ring from the top of your 1977 Chevrolet pickup truck ignition key tumbler. Slide the ignition key tumbler out. Remove the wiring harness from the end of the key tumbler.
Use the opportunity to replace the ignition. Key needs to be in On position for removal.
To remove the "key" ignition, insert a small screwdrived in the hole directly below the ignition in the column. You will need to have the key in the ON position otherwise the ignition will not come out of the column.
Removing a ignition lock cylinder from a 2002 ford windstar with no key
i have a 06 Chevy cobalt and can't get the key out of the ignition switch