Ok so it took some time to work out. The rear manual window winder is held on by a horseshoe wire sir clip. Its between the handle arm and the plastic washer that sits on the door covering. I used a flat blade screwdrive to push it out. The closed end of the clip can be seen on the end of the arm when the handle is pointing to 6 o'clock and you push the driver between the arm and washer. you can't release the clip from this side. Turn the arm to 12 o'clock and use the screw driver to push down on the clip open end. Its a bit of a fiddle but can be done. To refit the handle push the clip onto the arm. check the arm position from the other door. press it on. It goes back on very easily. hope this helps.
take window adjuster case of...remove the nut, is there a special tool to remove the mirror unit. There is a thread on the new mirror which goes into the door
To fit a door window in a Fiat Punto, first, remove the door panel by unscrewing the fasteners and carefully prying it off. Next, detach the old window by unbolting it from the regulator and sliding it out. Position the new window in place, secure it to the regulator, and then reassemble the door panel by reversing the removal steps. Finally, test the window's operation to ensure it moves smoothly.
it is in the engine fuse box. number 26 is the passenger window fuse
The washer tank may be empty, or the pump not working.
On a mk1 I paid £70 which included fitting.
Use hammer.
if its on a punto gt is a lot of work.have to remove inlet manifold costs a lots for the job to be done in a garage.
mel de polo de cambrio
open the door then drive into it with another car and it should remove it safely if not just use a hammer
You will have to remove the air filter casing to get at them they are At the end of the HT leads from the coil
To remove the front seat from a Fiat Punto, first, slide the seat all the way back to access the rear bolts. Use a socket wrench to remove the bolts securing the seat to the floor. Next, tilt the seat forward to access and remove the front bolts. Finally, disconnect any electrical connectors (if applicable) and carefully lift the seat out of the vehicle.