To remove the rear wing on a Renault Clio MK3, first, open the hatch and locate the screws or bolts securing the wing to the tailgate. Carefully remove these fasteners using the appropriate tools. Once the screws are removed, gently lift the wing off the vehicle, ensuring to disconnect any wiring if applicable. Finally, clean up any adhesive or residue left on the tailgate.
what model is it? i.e mk2 2.0 172 or mk3 1.2 16v? mk3 1.2 16v
no i dont think it will they are totally different shape
On a Clio MK3, the blower resistor pack is typically located behind the dashboard, near the blower motor. To access it, you may need to remove the glove compartment and some trim panels. It's usually mounted on or near the heater box. If you're having difficulty locating it, consulting a repair manual specific to your model can provide detailed guidance.
It is in the fuse box next to the battery under the bonnet. Regards Chris
theres usally either 2 screw caps on the air pipes under the bonnet on a mk3 its under the drivers wing,you have to remove the wing liner and its at the front its like a alloy cylinder
H7 for headlight. H7 for cornering lamp. H1 or H7 for main beam Hope this is of use to everyone.
hi you havent said what year your clio is but if it is pre 1998 mk3 it has a long 7mm bolt between the battery and relay box assenger side of battery good luck. On 1998+ Clio 2s, there is a bolt between the battery and the electrics box. It's on the passenger side too. To unscrew the bolt, you'll need a 13mm spanner, although it's sort of blocked by the battery, so ideally you'll have a wrench with a screwdriver handle so you can get down there easier. Hooray!
You need to remove; Both front Arch liners - 3-5 Grommets not sure exactly how many there are and 2 Torx screws underneath holding them on. (Do this on both sides) The 2 bolts and 2 clips you see when you open the bonnet (Where the bonnet catch is) 2 bolts underneath holding the under-tray on. And finally look through the arch gap like where the bumper meets the wing there's 1 bolt on either side undo both of them and your done. P.S There is nothing else holding it on, may seem like it, just keep wiggling it. this is because the bumper and wing slot together and REMEMBER to put some protection underneath you dont want it smashing off the ground Hope this helps
i have been on this subject with a shop keeper for my clio mk3 , told me there are diff types of antfreeze, but on making a call to renaults they told me that there should be no differents in them they should be suitable for all engines as long as you don't mix the colours together, it should say suitable for all engines on the tub or bottle.
on a mk3 Espace the ECU is bolted on to the drivers (left) hand side of the bulkhead and is enclosed in a grey coloured box with clips.
The Knob is threaded , Just unscrew it by hand
easy two plastic screws under seat