0
This is an answer from another forum, sounds about right though.:remove the panel inside the trunk behind the tail lamp lense. Sometimes that panel is held on by plastic wingnuts and other times it is a round plastic retainer with a slot in it for a flatblade screwdriver to turn out. Once out the build access might be obvious. Otherwise look for some 10mm nuts that look like they are behind the tail lamp area. Remove them all and then push on the studs or pull on the lenz to remove it. Once the lenz is out then the bulb retainer gets pushed and then the socket twisted.
What else can I help you with?
How do replace tail lamp bulb 2005 Xterra?
how to replace tail lamp 2005 xterra
How do you install tail light bulb Chevy Cobalt 2006?
Remove tail light housing. Remove lamp. Replace lamp. Replace tail light housing.
How do you replace a tail light in a 1996 Cadillac?
Inside the trunk remove the fasteners that hold carpet on backside of lamp's. Then you can unscrew the caps that hold the light. Remove from car and replace the bad bulbs. Its really not hard at all.
How do you replace tail lamp assembly in Pontiac vibe?
To replace the tail lamp assembly in a Pontiac Vibe, first, open the rear hatch and locate the access panel or screws securing the tail lamp. Remove the screws or panel, then gently pull the tail lamp assembly away from the vehicle. Disconnect the electrical connector and replace the old assembly with the new one, reconnecting the electrical connector and securing it in place with screws. Finally, test the new tail lamp to ensure it functions properly before closing the access panel.
How do you replace a left rear turn signal light on a 2001 Blazer?
For any Gen II (1995 - 2005) Blazer, Jimmy, or Bravada, it's all the same. Open the hatch. On the side of the door jamb, you'll see two screws - those hold the tail lamp assembly in place. Remove those, and the whole tail lamp assembly will come out. The bulb holders are in the back of the tail lamp assembly - rotate them counterclockwise, and they will come out. Then you can replace the bulb, put the lamp holder back into the tail lamp assembly, and the installation is the opposite of removal. Pretty simple stuff.. only tools required are a short Phillips screwdriver.
What bulb do you need for the rear blinker on a 2001 Ford Mustang?
According to the 2001 Ford Mustang Owner Guide : Tail lamp , Brake lamp , Turn lamp takes ( # 3157 K bulb )
How to remove brake light lens ON 2001 DODGE RAM 1500 VAN?
If you are talking about the tail light the lens is not a separate part of the lamp assy. Replace the complete assy by removing the two screws on the outside and unpluging the lamp socket.
How do you replace tail gate latch for a 2001 ford 150?
How do you replace the tail gate latch on a Ford f150
How do you replace a rear tail light lens on a Cadillac Escalade?
lift the tail gate and there are two phillip head screws on the metal by the tail light.
How do you replace a tail lamp on a Mazda 323 2002?
To replace the tail lamp on a 2002 Mazda 323, first, open the trunk and locate the access panel behind the tail light. Remove the screws or clips holding the panel in place. Disconnect the electrical connector from the old tail lamp and remove the bulb by twisting it counterclockwise. Insert the new bulb, reconnect the electrical connector, and reassemble the access panel.
How do I replace tail lamp 2003 Volvo v70?
To replace the tail lamp on a 2003 Volvo V70, first, open the rear hatch and locate the tail lamp assembly. Remove the screws or clips securing the assembly, then gently pull it out from the vehicle. Disconnect the electrical connector and replace the bulb or the entire assembly as needed. Reconnect the electrical connector, position the assembly back into place, and secure it with screws or clips before closing the hatch.
How do you replace the tail light lamp on a Pontiac Aztec?
It is a Pontiac Aztek. Light a match and get some marshmallows.
