To replace the heater resistor in a 2006 VW Polo, first ensure the vehicle is turned off and disconnect the battery to prevent any electrical issues. Locate the heater resistor, typically found behind the glove compartment or under the dashboard on the passenger side. Remove the screws or clips holding it in place, disconnect the wiring harness, and then replace it with the new resistor. Finally, reassemble everything and reconnect the battery to test the new resistor.
How do I replace rear brakes on a VW Polo GTI
Try checking the fuses.
On a 1989 VW Fox, the heater resistor is typically located under the dashboard on the passenger side, near the heater blower motor. It is usually mounted on or near the heater box. To access it, you may need to remove some panels or the glove compartment for better visibility and access.
You will want to replace a brake light switch on a VW Polo professionally. You do not want to make a bigger situation than you already have. A mechanic will do the job correctly.
You need take out the whole dash board and your steering wheel
Under a cover, under the glove box. Plug in component, easy replacement.
Blower motor, resistor, wiring or control problem are common causes
hi the resistor may not be gone it might be the brushes in the Fan motor if it works on 3 -4 setting then dies the resistor is on the left behind glove box remove glove box you will see grey part this is resistor to remove fan take of cover first then turn fan to right it comes out then check brushes if worn replace fan from scrap yard
replace c/v joints
http://faculty.ccp.edu/faculty/dreed/campingart/jettatech
It has to be professionally done at a dealer or collision repair