To replace the front speakers in a Renault Scenic, start by removing the door panel. Carefully pry off the panel using a trim tool, taking care to detach any screws or clips. Once the panel is removed, disconnect the old speaker's wiring harness, unscrew the speaker, and replace it with the new one, reconnecting the wiring. Finally, reattach the door panel, ensuring all clips and screws are securely fastened.
on my Renault scenic 1998 version it was at the front of the engine bay with a red cap but as for the 2003 version i dont have no idea hope this helps
13cm
The air filter on a 2002 Renault Scenic is located on the driver's side of the engine compartment. It is under the huge, black box at the very front, above the driver's side headlight. The cover is held on by a clip at the front.
Which speakers are you trying to replace? Front or rear?
30 mm
No, a Renault Scenic is front wheel drive. However, the rear wheels often wear faster than the front wheels, which would only normally happen with rear wheel drive. This is due to the unusual wheel alignment on this car.
Its located next to the courtesy light in the roof, its under the black dome at the front.
Under a plastic cover in front of the rear rear fold able seats
To replace the suspension top bearing on a Renault Scenic, start by safely lifting the vehicle and removing the front wheel. Next, detach the suspension strut from the top mount by removing the nuts and bolts, then carefully take out the strut assembly. Replace the old top bearing with a new one, ensuring it is seated correctly, and reassemble everything by reversing the disassembly steps. Finally, double-check all connections and lower the vehicle back to the ground.
Pressure is: Front: 31 and rear: 32.
To replace the speakers in a Town and Country you will need to remove the old ones first. Consult your owners manual for how to take out your speakers.
To change the front side lights of a Renault Scenic, first, open the hood and locate the back of the headlight assembly. Depending on the model, you may need to remove the plastic cover or unclip the bulb holder. Carefully twist the bulb holder counterclockwise to release it, then replace the old bulb with a new one, ensuring it is securely in place before reassembling everything. Finally, test the lights to confirm they are working properly.