To replace the Power Steering belt on a Saab 900, first, disconnect the negative battery terminal for safety. Loosen the tensioner bolt and the belt tension using a wrench, then remove the old belt from the pulleys. Install the new belt by threading it around the pulleys, ensuring it is seated properly. Finally, adjust the tension on the new belt, tighten the tensioner bolt, and reconnect the battery.
What have to do replace the belts water pump power steering
How do you replace power steering belt on 2003 Mazda protege ?1.6
Loosen the tensioner pulley. The power steering belt will come loose. Remove the power steering belt. Reverse the process to install the new power steering belt.
To change a power steering belt on a Rover 214, unbolt the power steering pump and pry the belt off the pulley. Replace with another steering belt and reinstall the steering pump.
How do you change the power steering belt on a 1996 lexus es300?
To change the steering pump in a 1999 Saab 93, first, remove the drive belt by loosening the tensioner. Next, disconnect the power steering lines and the electrical connector from the pump. Unbolt the pump from its mounting bracket and replace it with the new unit, ensuring all connections are secure. Finally, refill the power steering fluid and bleed the system to remove any air.
Saab dealer quoted 1 hour to replace the serpentine belt. The cost of the belt was $60 canadian.
Replace the power steering pump located just right of the windshield washer fluid reservior in the left front corner of the engine compartment. Add power steering fluid and replace serpentine belt. (Belt part #: 425K4)
The squealing could be that you need to add power steering fluid. Also you should check the belt that operates the power steering pump, if bad replace it. If the power steering pump is full and the belt is ok, then you may need to replace the power steering pump.
Remove the power steering belt first then the alternator belt will go on.
Without knowing what kind of car and what engine, there is no answer.
The adjusting pulley for the power steering is found on the side of the engine under the power steering pump. Loosen the bolt that keeps it tight and the belt will have some slack to slide off the pulley.