Disconnectr the wires from the switch and connect them together
Disconnect the 2 wires from the switch and connect them together
Red
The neutral safety switch is on the side of the transmission. It screws into the side and has a small three wire plug.
The safety switch is located under the radiator belt. You can trace the positive wire from the battery and it will end up at the safety switch.
The year, make and model would help.
because its much safer to switch the hot wire then the neutral wire because if you are working on a light fixture for example and the switch is off if you ground yourself out to the neutral you become the load or return. a neutral shock can me more dangerous at times
To override a neutral safety switch, locate it (it should be at the base of the steering column) and remove the green and brown wire. Connecting these two wires together will bypass the safety switch and your reverse lights will turn on.
To add a neutral wire to a light switch for proper electrical installation, you may need to run a new wire from the switch to the electrical panel. This wire should be connected to the neutral bus bar in the panel. It is important to follow all safety guidelines and consult a licensed electrician if you are unsure about the process.
The color of the neutral safety switch wire can vary depending on the make and model of the vehicle. However, it is commonly found to be yellow or purple. Always consult the vehicle's service manual or wiring diagram for accurate information specific to your car.
If only two wires are available for the circuit and the switch requires a neutral wire, you may need to run a new wire that includes a neutral to properly install the switch. It is important to ensure all wiring is done in accordance with local electrical codes to maintain safety. If unsure, consult a licensed electrician for assistance.
To add a neutral wire to a light switch, you may need to run a new wire from the switch to the electrical panel. This wire should be connected to the neutral bus bar in the panel. It is important to turn off the power before working on any electrical wiring to ensure safety. If you are unsure about how to do this, it is recommended to consult a licensed electrician for assistance.
Three wire switch on the driver side of trans, just above oil pan.