0
To remove the distributor on a Peugeot 205, first disconnect the battery to ensure safety. Then, remove any necessary components obstructing access to the distributor, such as the air intake or ignition leads. Unscrew the distributor cap and mark the position of the rotor for reassembly. Finally, unscrew the distributor from the engine block and gently lift it out, taking care to avoid damaging any surrounding components.
What else can I help you with?
Who made the peugeot 205 and in what year?
The Peugeot 205 is made by the French car manufacturer Peugeot. The Peugeot 205 was a small econoical car manufactured between 1983 and 1998.
What is a similar car to the peugeot 206?
A similar car to the Peugeot 206 is the Peugeot 205 which the Peugeot 206 is modeled after with minor modifications and upgrades from the Peugeot 205 to the Peugeot 206.
What does ditloid P 205 mean?
Peugeot 205
What is the hp for a Peugeot 205 trio s?
peugeot 205 trio 1.1 has a bhp of 55 as standard
How do you remove and replace the windscreen on an peugeot 205 1.8cc diesel?
Cut the rubber seal and gently push the windscreen out.
Will a 1995 Peugeot 205 osf door fit a 1993 Peugeot 205?
if its a 205 gti the door will go right on as 1993 & 1995 are both phaise 2 models if its a standared 205 not to sure.
How much liters enter in Peugeot 205 fuel tank?
all peugeot 205's have a fuel capacitie of 50 litres
How do you remove the matrix out of your peugeot 205 k reg?
The whole front of the dash board has to come out . I am doing mine as we speek and its a nitemare !!!!
How do you remove boot lock on peugeot 205?
Remove the inside boot trim and then pull away the metal clip holding it in. It can then just be pulled straight out from outside the car.
Peugeot 205 style where is the horn?
behind the headlights
Is the Peugeot 205 GTI ugly?
Simple - NO IT IS HOT!
Where is the ignition timing aperture on a peugeot 205 gti 1.9?
On a Peugeot 205 GTI 1.9, the ignition timing aperture is located on the engine block near the flywheel. Specifically, it can be found on the left-hand side of the engine, typically near the distributor. To check the ignition timing, you will need to connect a timing light to the appropriate wire and observe the timing marks on the crankshaft pulley.
