These axles and the Mitsubishi Galant axles get rusted in so tightly, that I have had to take the whole steering knuckle assy off with the axle still attached ad use a hydraulic press to separate the axle. I have also had to just replace the axle, hub/bearing, steering knuckle and backing plate on one also.
Replace the complete halfshaft assembly, it is much easier than trying to replace the cv joint itself.
If you dont know how to replace spark plugs I recomend you go to someone that does and have him show you because you might do more bad then good trying to change them for the first time.
If you're trying to replace the rear wheel bearing and all you can find is the rear hub assembly, it probably means that you can't get just the bearing. Many vehicle manufacturers press the bearing into the assembly at the factory and there is no way to replace just the bearing. If they're offering the assembly, that's probably what you'll need to buy.
Victoria
trying to change a burn out stop light on a Lincoln continatial how do I get the tail light assembly off?
I'm trying to replace the headlight assembly for a 2000 Jeep Grand Cherokee Lerado. What bolts or screws do I remove
A vampire trying to kill Bella
It does have CV joints but, it is best to just swap out the complete axle assembly than to replace only the CV joint. You will spend much time and almost as much money trying to replace the CV joint than to just purchase a reconditioned axle assembly and swap it.
i have a 2002 Chevy trailblazer. im trying to switch out my blinker light and i was told i need to take my light assembly out. how do i do this. i took off the grill and im stuck from there. can you help.
The blaster 200 is a 2-stroke, therefore you need to mix the gas and oil, trying running a 50:1 ratio, 50 parts of gas to one part of oil.
July 2009. Still trying to find out.
Yamaha 1981 YZ465H Engine