It does have CV joints but, it is best to just swap out the complete axle assembly than to replace only the CV joint. You will spend much time and almost as much money trying to replace the CV joint than to just purchase a reconditioned axle assembly and swap it.
You can not. you have to change the whole cluster.
This is not a easy task..Suggest you get that done by a good mechanic.I have found it to be less expensive to change the whole axle [parts & labor considered ] Z-Man
This is not a easy task..Suggest you get that done by a good mechanic.I have found it to be less expensive to change the whole axle [parts & labor considered ] Z-Man
You have to change the whole lower control arm.
You just do it. Hint there is a tricky switch you need to find once you do the whole things fall apart.
To change a front signal bulb on a 98 Toyota open the hood take out a Phillips Head Screw holding a grey bracket on the outside piece that holds the bulb. Slide the whole outside plastic straight ahead, you may have to move it by pushing it forward with a scre driver. Replace bulb.
You cant just change the bulb, you have to change the whole headlamp.
Replace the whole sway bar link.
You can not just change the ball joint , you have to replace the whole lower control arm with ball joint.
90 whole horsepower, which is almost 1hp per cubic inch so it's pretty respectable, especially for 1980.
I'm looking for it right now.. if i find i will write back in a short period of time..
you do not need to change gaskets just a good flush will do the trick If the transmission pan has been removed, then you should replace the gasket. The only other reason for changing it is if it is leaking transmission oil from the gasket. Otherwise the above answer is good. Just watch out that whoever does it doesn't over tighten the plug. Toyota overtightened my wifes and trashed the threads. Had to replace the whole pan and Toyota wouldn't fess up to their mistake! There goes another couple hundred bucks!