A dimmer left turn signal indicator on your Audi A6 could indicate a faulty bulb or a poor connection in the circuit. It's also possible that the turn signal relay is malfunctioning, leading to uneven brightness. To diagnose the issue, inspect the left turn signal bulb for any signs of damage or wear, and check the wiring for corrosion or loose connections. If the problem persists after these checks, consider consulting a professional for further inspection.
bad bulb, relay, wiring, turn signal switch
Turn your indicator switch to left/right and the parking light will come on for that side.
Indicator lights on an Audi can be reset by a mechanic. The cars manual will also give instructions on how to reset this light as well.
The turn indicator relay in an Audi TT is integrated with the hazard switch. To replace the relay you would need to replace the hazard switch.
Signal lights staying on withot flashing indicates either front or rear signal bulb not working on the Audi
The service indicator on an Audi A6 can only be reset with something called the VAGCOM. One may be found on line but it would be better to take in into an Audi dealership or authorized mechanic because more damage can be caused.
The flasher is right above the fuse box, pull it out, and replace it with a good one.
Replace turn signal flasher
The windshield fluid level indicator light on a 2001 Audi TT may stay on even when the reservoir is full due to a malfunctioning float sensor or a faulty wiring connection. The float sensor, which detects the fluid level, might be stuck or damaged, preventing it from signaling that the tank is full. Additionally, corroded or loose electrical connections could disrupt the signal to the dashboard indicator. Checking and replacing the sensor or repairing the wiring may resolve the issue.
behind the hazard button, its built as complete assembly for Turn/hazard signal
On the 1998 Audi A6, the turn signal bulb can be replaced by opening the hood. Reach into the turn signal from the fender wall and push in and turn the old bulb to remove it. Push in and turn to replace with a new bulb.
Bulb is burned out.