If the lift gate door on your ML320 is rattling, it could be due to loose hinges, worn-out rubber stoppers, or misalignment. Inspect the hinges and fasteners for tightness, and check the rubber bumpers for wear. Additionally, ensure that the latch is engaging properly when closed. If the issue persists, consider consulting a mechanic for further diagnosis.
behind the back panel on the lift gate. Remove the door panel on lft gate and there it is rivited to the cover plate
Door Latch 1. Disconnect the negative battery cable. 2. Remove the lift gate trim panel. 3. On navigator, remove the license plate bracket. 4. Remove the lift gate latch screws. 5. Separate the lift gate latch from the lift gate. 6. Detach the door open warning lamp electrical connector *** Warning*** 7. Disconnect the lift gate latch control cable. 8. Remove the lift gate latch. 9. The installation is the reverse of the removal. > If necessary, use Multi-Purpose Grease Spray F5AZ-19G209-AA or equivalent meeting Ford Specification ESR-M1C159-A to lubricate the latch.
The lift gate on a 2003 Dodge Durango can be opened from the inside if the latch is not working. There is a latch on the floor close to the door that can be tripped with the use of a screwdriver to open the gate. The cable for the gate might need to be repaired after this.
Close it hard
they are electrical connections for the stereo speaker and door lock.AnswerSee "Related Questions" for in-depth discussion on rear lift-gate sensors
It has a lift gate or tail gate-not both.
That's the door on the rear of the Explorer , where you can open the window separately or open the liftgate with the window closed
On a 2001 Ford Windstar : The liftgate is the big door at the rear of the vehicle that opens by going up
gate
I think you have to remove the lift gate interior plastic off. I haven't looked at ours yet so look for any exposed Philips screws. Remove if any, and if it's anything like removing the door panel you'll have to pry it off the lift gate. The fasteners that hold the lift gate panel are replaceable if they get ruined. good luck
It's right under the Jeep logo on the lift gate.
To change the lift gate cylinders, first, ensure the lift gate is fully supported and secure to prevent it from falling. Remove any retaining clips or screws securing the old cylinders, then detach them from the lift gate and the vehicle frame. Install the new cylinders by connecting them to the lift gate and frame, securing them with clips or screws, and then test the lift gate to ensure smooth operation. Always consult the vehicle's manual for specific instructions and safety precautions.