0
As far as I know, the older BMW uses brake sensor inline with the brakpads. Once the pads are low enough, the sensor get worn down, which use to conduct electricity no longer do so. As a result, the sensor lights are tripped. To reset the lights, you need to replace the brake sensors.
What else can I help you with?
How do you reset an abs light on 1997 BMW 540i?
how do I reset tne brake pad sensor light on a 1997 BMW 318i
How do you reset the brake pad light on a BMW X3?
you have to by a replacement sensor for your front and rear pads.
How do you reset the brake sensor light for a 325i BMW?
The brake pad sensor light is reset by leaving the key on engine off for about 20sec. If it does not reset retry, if it still does not reset check the wiring of the left front and right rear pad sensors
How do you reset brake light for 2004 BMW 745?
how do you reset brake warning light 0n 745li bmw
How do you reset brake light on 2006 BMW 525i?
how can i reset rear brake pad warning light on 2006 bmw 525i
How do you reset the brake sensor light on a 1995 BMW 740il?
To reset the brake sensor light on a 1995 BMW 740iL, first ensure that the brake pad wear sensors are functioning properly and have been replaced if necessary. Next, disconnect the negative battery terminal for about 10-15 minutes to reset the car's electrical system. Reconnect the battery, and the brake sensor light should be cleared. If the light remains on, it may indicate a persistent issue that needs further inspection.
BMW brake light reset?
Put key in ignition in the second position and open the driver door. should reset in about 10sec.(assuming that you've changed the brake pad wear sensor)
How do you reset BMW 525i 2007 brake light?
You will need a compatible BMW scan tool to reset this service light from the I drive system.
When to service BMW x5?
Had brake linings replaced but brake light and check brake lining light will not go out how do I reset.
How do you reset brake fluid light BMW 2007 525i?
You will need a compatible BMW scan tool to reset this service light from the I drive system.
How do you reset brake light on 2003 BMW x5?
To reset the brake light on a 2003 BMW X5, first, ensure that the brake light bulb is functioning properly and replace it if necessary. Next, turn on the vehicle's ignition without starting the engine. Then, press the brake pedal firmly and hold it down for a few seconds. Finally, release the pedal and check if the brake light has been reset and is functioning correctly.
How do you reset brake pad light on BMW x3?
To reset the brake pad light on a BMW X3, start by turning on the ignition without starting the engine. Then, press the gas pedal three times while holding the brake pedal. After that, turn off the ignition and then start the engine; the brake pad light should be reset. If the light persists, it may indicate an issue that requires further inspection.
