The instrument panel buttons on a Land Rover Discovery 1 control various features and functions of the vehicle. These typically include controls for the headlights, fog lights, and hazard lights, as well as buttons for the air conditioning, rear window defroster, and other essential systems. Some buttons may also activate specific off-road features like traction control or differential locks, enhancing the vehicle's capability in challenging terrain. The layout and specific functions can vary depending on the model year and trim level.
To replace the lights on the instrument panel of a Land Rover Discovery TD5, first, disconnect the vehicle's battery to ensure safety. Remove the instrument panel by unscrewing the securing screws and gently pulling it out. Locate the bulb holders on the back of the panel, twist them counterclockwise to release, and replace the burnt-out bulbs. Reassemble the panel and reconnect the battery to test the new lights.
where is the fuse panel for a land rover
To change a dash light bulb on a Land Rover Discovery 2, start by removing the dashboard panel. Use a flathead screwdriver to gently pry off the panel, being careful not to damage any clips. Locate the faulty bulb in the instrument cluster, twist it counterclockwise to remove it, and replace it with a new bulb. Finally, reassemble the dashboard by snapping the panel back into place.
Should be under steering wheel. Use a screwdriver to undo the panel
In the fuse box...it will be labeled panel, or cluster , if the fuse is okies its the light switch.What if it is only half of the lights on the instrument panel that are out? Just the cold/hot dial and 5 buttons?
Inside panel passenger side under dash by door.
This is a complicated procedure. It is best left to the professionals so take the vehicle in to your local mechanic.
The buttons on the lower left corner of the instrument panel adjust the brightness of the display in five steps; push the + or - buttons. The settings are independent for when the headlight switch is on and off.
Passenger side. Outer wall kick panel where the passenger feet are. Remove panel. You should have 2 or 3 relays. Mine was the middle one.
On a 1997 Land Rover Discovery, the OBD-II port is typically located under the dashboard on the driver's side. You can find it near the steering column, often to the left or right of the pedals. It may be covered by a panel, which can be easily removed to access the port.
In the discovery the fuse panels are behind the panel in front of the drivers right knee (RHD) and under the bonnet above the drivers wheel. In the Range Rover the fuse panels are under the drivers seat (RHD) and under the bonnet above the drivers wheel.
you take apart the dash and get to the instrument panel. then you take the instrument panel out and on the back of the panel you'll will see the lights