answersLogoWhite

0

On the Peugeot 407, the spark plugs are located on the engine cylinder head, typically covered by ignition coils or a cover. For accessing them, you may need to remove the ignition coil packs, which are mounted directly above the spark plugs. The exact location can vary slightly depending on the engine type, so consulting the vehicle's manual is advisable for precise instructions.

User Avatar

AnswerBot

2d ago

What else can I help you with?

Related Questions

On a direct injection peugeot 407 diesel are there heater plugs?

yes


Where is fuse for brake light for Peugeot 407?

where is the fuses for a peugeot 407


How do you replace Peugeot 407 serpentine belt?

How do you replace peugeot 407 serprntine belt


How do you change glow plugs on a peugeot 407?

To change the glow plugs on a Peugeot 407, first disconnect the battery to ensure safety. Then, remove the engine cover if applicable, and carefully detach the wiring harness from the glow plugs. Using a socket wrench, unscrew the old glow plugs and replace them with new ones, taking care not to overtighten. Reconnect the wiring harness, replace the engine cover, and reconnect the battery to complete the process.


When do you change timing belt on a Peugeot 407 hdi 16 valve?

when to chang timing belt on peugeot 407 hdi 1.6


How do you reprogram a lost keyfob for a Peugeot 407 sw 2007?

Procedure to reprogram a lost keyfob for a Peugeot 407 sw 2007


How much oil in Peugeot 407?

5.25l


Where is the coin compartment in the Peugeot 407?

in the trunk


What are some places to look for a Peugeot 407 cheap?

To find a cheap Peugeot 407 you may look in the newspaper or even maybe a used car dealer. You possibly may be able to find a Peugeot 407 cheap through Craigslist or a number of other online resources.


Where is the fuel cut off switch in a peugeot 407?

Weare the location


How do you replace the spark plugs on a Peugeot 307?

How do you replace the spark plugs on a Peugeot 307?


How do you get the cover of a peugeot 407 to get to the spark plug?

On my 2007 it was attached with rubber plugs, so I had to just lift it up from each corner a time with force of about 5kg and yank at the same time.