You don,t---remove and lubricate and bench check before re-fitting!
Could be many reasons, try replacing the starter motor. Also check the power/health of the battery.
Fitting the wrong size starter motor in a Fiat Punto can lead to several issues, including improper engagement with the flywheel, which may prevent the engine from starting. It can also cause mechanical damage to the starter or the engine components due to misalignment or excessive strain. Additionally, electrical incompatibilities may arise, potentially leading to short circuits or damage to the vehicle's electrical system. Overall, using the correct starter motor size is crucial for optimal performance and longevity of the vehicle.
where is the fuse for the heater motor ina fiat punto grande 1.2
Use hammer.
Found mine way just a wire on the blower motor (under the glovebox) had come lose. Popped it back in and weyhey!!!
open the door then drive into it with another car and it should remove it safely if not just use a hammer
Probably the temp sending unit.
To replace the heater motor in a Fiat Punto, first disconnect the battery and remove the dashboard trim to access the heater assembly. Unscrew the bolts securing the heater motor and disconnect the electrical connector. Remove the old motor and replace it with the new one, ensuring it is securely fastened. Reassemble the dashboard and reconnect the battery to complete the installation.
on the steering column beneath steering wheel
Due to water damage caused by blocked drainage pipes leading from the bottom of the compartment in which it is mounted. There are two of these pipes that get blocked with leaves etc.
To change the screen wash motor on a Fiat Punto, first, ensure the vehicle is turned off and the keys are removed. Locate the motor, usually found at the rear of the washer reservoir; you may need to remove the reservoir for easier access. Disconnect the electrical connector and the hose, then unscrew the motor from its mount. Replace it with the new motor, reattach the hose and connector, and test the system before reassembling anything.
behind the front bumper, on the left hand side.