The speedometer cable on a 1992 Mazda MX3 is typically located on the transmission housing. It connects to the speed sensor, which measures the speed of the vehicle and sends that information to the speedometer on the dashboard. To access the speedometer cable for inspection or replacement, you may need to remove some components under the hood and possibly underneath the vehicle.
If your speedometer isn't working in your 1992 Volvo 740, the issue could be due to a faulty speed sensor, a broken cable, or a malfunctioning instrument cluster. Start by checking the speed sensor located on the transmission; if it’s damaged or disconnected, that could be the problem. If the sensor seems fine, inspect the speedometer cable for any breaks or wear. If those components are in good condition, the issue might lie within the instrument cluster itself, which may require professional repair or replacement.
TAKE IT TO THE A PLACE TO GET IT FIXED BEFORE YOU MESS IT UP EVEN MORE! where is the cable located?
my 92 yota has a sensor. the plug is located on the passenger side of the trans.
it should be at the back of the gear box but most of them are electric its all down to what model
It's the thick black cable running into the firewall located next to the master cylinder. The one end plugs directly into the speedometer, the other end directly into the top part of tranny.
speedometer cable is gummed up inside the housing.Remove cable from speedometer.Pull out inner cable. Lubricate with good grease and install.
there isn't one- equipped with an electric speedometer
Broken speedometer cable.
It is probably a bad speed sensor. The speed sensor is located on the transmission and sends a signal to the speedometer. It acts like a speedometer cable only sending electronic pulses instead of turning like a cable does.
Yes, the cable goes from the transmission to the back wall into the dashboard
If a 1992 Honda Civic's speedometer is erratic, the problem could be the speedometer cable. It could also be the speedometer sensor malfunctioning. Check both components carefully.