answersLogoWhite

0

What else can I help you with?

Related Questions

Were is the dme relay located on a 1984 Porsche 944?

The DME relay is located under the bonnet in a fuse box below the windscreen.


Were is the dme relay located on 1989 Porsche 944?

Relay is located under the bonnet in a fuse box at the scuttle pannel.


Were is a dme relay located on a 1985 Porsche 944?

1985 was a changeover year for the 944. Early cars (sometimes refered to as 1985.1, with three separate round guage pods in the dash) have the DME relay located on the relay board in the driver's footwell, under the dashboard. The DME relay is in position 2 of the relay board, second one from the left. Later series cars (1985.5) have the fuse and relay board under the hood, on the left hand side, just in front of the windshield. Open the box up and there should be a diagram on the inside of the lid.


Where is the dme relay located on BMW 318ti e36?

behind the battery


Where is the dme ecu located on a 1988 Porsche 944?

passenger side floor board pull the carpet up and you should see it ?


Why won't my Porsche 944 not start after sitting for three years ran great before?

check your DME relay and your crank and speed sensors on the back side of the bellhousing. look up Clarks Garage on google for how to bypass and test the DME and how to test your sensors.


Where is the 1987 BMW 635csi ecu dme relay located?

there is a relay on the inner fender the ecu is in the back of the glove compartment


Where is the ignition control unit located in a porhse 944?

Only the 944S's used an actual ignition control module, and it was located on the fender under the coolant expansion tank. The other 944's and 924S's used the signals from the referance sensors to the DME and the DME controlled everything. The DME's are located: 82-85 - under the steering wheel. 85.5-91 under passengers kickpanel, pull back carpet (it's velcro'd in under the dash at the / ) remove 4 screws to remove the wood panel, remove 4 plastic screws to remove the metal piece that holds the DME in.


What if your 1984 Porsche 944 won't start but the engine turns It seems there is no fuel getting to it and the fuel pump relay was just changed I am hoping it's just clogged What else might it be?

It is likely that you have a bad camshaft and/or crankshaft reference sensor. Without the proper signal from both sensors, the computer will not power up the DME relay which results in no power to the ignition coil or the fuel pump relay. The two sensors are identical and are available from Paragon Products.


Porsche 944 will not start It has a new fuel pump fuel filter battery rotor sparks plugs and wires fuel pump relay DME fuel pressure regulator It was running fine and then it stopped. Crank P Sensor?

dme motronics unit , do you think you got into some water , under dash above knees ignition coil same side as battery 1984 944 all the way to the front (plastic black cap covers water can still get trapped and if theres no cover --- better get it dry check timing belt, i had problem with my timing belt that had a bad spot and after stopping engine it would not start


Where is the igntion control unit on 944 Porsche?

follow the middle wire on your distrbuter cap. or are you looking for the dme? that's under the passenger floor carpet.


Where is the temperature switch located at at on a Porsche 944?

Which temperature switch, there are 2. One is the DME temp switch and that one is close to the water inlet at the top of the motor and usually has a blue connector. The dash sensor is located in the middle of the block under the intake manifold and is a single wire sensor.