answersLogoWhite

0

In the Citroën Picasso Xsara, the fog light switch is typically located on the headlight control stalk, which can be found on the right side of the steering wheel. You can activate the fog lights by turning the switch or pulling it towards you, depending on the specific model year. Additionally, some models may have a dedicated button on the dashboard. Always refer to your owner's manual for precise information.

User Avatar

AnswerBot

1w ago

What else can I help you with?

Related Questions

Where is the brake light switch on a Citroen Xsara Picasso?

There is a switch behind the brake pedal. Fairly easy to replace, or a 10 minute job at a garage.


Citroen xsara Picasso dashboard light bulbs?

Citroen xsara Picasso dashboard light bulb is the bulb that's for the dashboard light climate control. The you tube web site gives you information as how to change the bulb.


Why does the battery light come on in your citroen xsara Picasso?

The alternator needs attention or replace


How do you change back light switch on a Citroen Xsara Picasso?

To change the backlight switch on a Citroen Xsara Picasso, first, disconnect the car battery to ensure safety. Then, carefully remove the switch panel using a flathead screwdriver or a trim removal tool to avoid damaging the surrounding areas. Disconnect the wiring harness from the old switch, replace it with the new one, and reconnect the harness. Finally, reassemble the switch panel and reconnect the battery to test the new switch.


How do you change brake light switch on a Citroen Xsara Picasso?

Remove the fuse board cover at the right hand side of the steering wheel, the switch is located behind the mass of cables, a quarter turn to the left will allow the switch to be removed.


Where is the brake light switch on a 2004 citroen xsara Picasso?

The brake light switch on a 2004 Citroën Xsara Picasso is located near the brake pedal assembly. It is typically mounted on the top part of the brake pedal bracket, where it can be activated when the pedal is pressed. To access it, you may need to remove the cover beneath the dashboard. Make sure to check your vehicle's manual for specific details and diagrams.


Does citroen xsara Picasso have a glowplug warning light?

Yes. Its the amber warning light on the central display with a picture of a coil on it. It is only used on the diesel version of the car.


How do you put service message out on a citroen Picasso?

Service Light Reset - Citroen Xsara (1997 on) Using button located at the right hand side of the speedometer dial. Switch the ignition off. Press and hold button. Switch on the ignition. Keep the button depressed Service Interval and "spanner" symbol will illuminate for five seconds.


Car shaped symbol with 2 dots at back followed by lollipop has appeared on the dashboard of your Citroen Xsara Picasso?

the light tells you that you have passed its service interval


How do you remove rearlight from citroen xsara Picasso?

go to the boot, get at the back of the light and pop 1 of the clips out with a flat head screwdriver, then just line up the 4 bits when replacing!


Where to put light deflectors on a citroen xsara Picasso?

To install light deflectors on a Citroën Xsara Picasso, place them on the headlight lenses according to the specific guidelines for your vehicle. Typically, deflectors should be positioned on the outer edge of the headlights to prevent dazzling oncoming drivers. Ensure they are securely attached and do not obstruct the light beam. Always check your local regulations regarding the use of deflectors when driving abroad.


How do you change light bulb behind heated rear window switch on xsara Picasso?

To change the light bulb behind the heated rear window switch on a Citroën Xsara Picasso, first, carefully remove the switch from the dashboard by prying it out with a flat tool. Once the switch is out, you may need to unscrew or unclip the cover to access the bulb. Replace the burnt bulb with a new one of the same type, then reassemble the switch and push it back into the dashboard. Ensure everything is securely in place before testing the switch.