0
What else can I help you with?
Where is crank position sensor on a 2002 Volvo s60 with a 2.4 engine?
where is the crankshaft position sensor located on a 2002 Volvo S60 2.4 engine
Where is the ignition coil on 1990 740gl Volvo?
This model probably has the Regina engine. The ignition coil should be mounted on the drivers side fender well close to the firewall.
Where can i find the ignition control module in a 1989 Volvo 740 gl?
In the 1989 Volvo 740 GL with a Bosch system it is located just above the steering column on the dash.
How do you change an ignition coil on a Volvo 740?
To change the ignition coil on a Volvo 740, first, ensure the engine is off and disconnect the negative battery cable. Remove the ignition coil's electrical connector and unscrew the mounting bolts securing the coil to the engine. Replace the old coil with a new one, reattach the mounting bolts, and reconnect the electrical connector. Finally, reconnect the battery and start the engine to ensure proper operation.
Where is the ignition control module located in the 1988 Volvo 240?
Under Dash Passenger side to the right of the kick panel
Where is PCV valve on 2004 Volvo S40?
The PCV valve on a 2004 Volvo S40 is located on the engine crankcase. It is a small rubber valve.
Where is crank position sensor on a 2002 Volvo s60 with a 2.4?
where is the crankshaft position sensor located on a 2002 Volvo S60 2.4 engine
Where is the crankshaft position sensor on 92 Volvo 240 B230F engine?
it is located on top of the bell housing behind the engine
Where is the PCV valve located on the 99 Volvo S80 T6?
The PCV valve is located in the engine area on the 99 Volvo S80T6. It is important to carefully study the user manual which has an illustration of the same.
Where is the temperature sending unit located on Volvo 240DL?
on left rear side of engine block
Where is the ECU located in a Volvo 240 1990?
Most 200 series Volvo share a similar design. Both the Ignition and Fuel Injection Electronic Control Units (ECU) is located behind the outside passenger-side kick panel. To get to it, remove the plastic panel and the overhead insulator, the Ignition ECU is mounted on the firewall, and to its right, the Fuel Injection ECU.
Is a Volvo marine engine the same as a Volvo car engine?
nope
