answersLogoWhite

0

Its located inside the top of the top radiator hose, loosen the clamp around the top of the top hose connected to the motor with needed tool, do not disconnect the end connected to the radiator. Pull the top of the top radiator hose back and you will see a small removable cylinder metal part, that is the thermostat. Please make sure to note how this part is sitting in the motor, the new one has to go in the same way or it wont work, remove the rubber ring out too, it should be on the thermostat and a new one needs to be installed with the new thermostat. The new rubber ring needs to go on just like the old one, it might seal onto the new thermostat so check the old one. Once the new rubber ring is on the new thermostat, place it in the area on the motor, just like the old one was and attached the clamp back around the hose and tighten the hose clamp. Start car and make sure no leaks are coming out top hose and that the car is running cool, not hot, then replace lost coolant by adding in the reservoir tank only, remove the cap slow so you don't get a spray of hot coolant on you, yea, this is going to leak out some when replacing the old thermostat in the beginning from the top hose and possible when adding new coolant to the reservoir, good luck.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where can you get a vacuum diagram for a 1993 Volvo 940?

You can get a vacuum diagram for a 1993 Volvo 940 on the AutoZone website. They have nine different diagrams that can be enlarged, and a list of the components.Ê


Where is thermostat located 1994 Volvo 940?

In a 1994 Volvo 940, the thermostat is located in the engine's coolant passage, typically near the top of the engine, at the junction where the upper radiator hose connects to the engine block. To access it, you usually need to remove the upper radiator hose and the thermostat housing, which is bolted to the engine. It's important to ensure the engine is cool before attempting to replace the thermostat to avoid burns or injury.


Where is the block temperature sensor located in a 93 Volvo 940?

In a 1993 Volvo 940, the block temperature sensor is typically located on the engine block, near the thermostat housing. It can be found on the driver's side of the engine, often near the cylinder head. This sensor monitors the engine's coolant temperature and sends the information to the gauge on the dashboard. If you're having trouble locating it, consult your vehicle's repair manual for a detailed diagram.


How do you test the radiator fan relay in a 1993 Volvo 940?

by changing it.


Where is the fan relay for 1993 Volvo 940?

In a 1993 Volvo 940, the fan relay is typically located in the engine compartment, near the fuse box. It is usually mounted on the driver's side, close to the battery. For precise identification, you may refer to the vehicle's manual, which provides a diagram of the relay and fuse layout.


Where is speedometer cable located on 1992 Volvo 940 gl?

a 1992 Volvo 940 doesn't have a speedometer cable. the speedometer is controlled electronically.


What kind of oil does a 1993 Volvo turbo 940 take?

5w-30


Where are the relays located on a 1995 Volvo 940?

Behind the ashtray....


Which class of car is the Volvo 940 defined as?

The Volvo 940 is defined as a Sedan. The Volvo 940 was one of the last rear wheel drive cars from Volvo. You can find more information about the Volvo 940 online from the Wikipedia. Once on the page, search for Volvo 940.


How do you know if the transmission is bad 1993 Volvo 940?

change the gearbox oil it is ATF.


What is the park plug gap for 1993 Volvo 940 GLE?

for b230f it would be 28


Where is the battery located on a Volvo 940?

facing the car, front left