It is behind the timing cover just behind the crankshaft pulley that runs the ac,ps,and fan/alternator belt.In short to replace this requires removing the timing belt.This takes about 3 hours or more to do this replacement.I assume you have a leak dripping antifreeze just below the crankshaft or a cooling or heating issue.I have done this job and unless your mechanically inclined take it to a shop for this service.Note it is a good idea to replace the timing belt,and tensioner when do the water pump.
The torque specs for the cylinder head on a b2200 are 59-64 ft lbs (cold).
Look under vehicle follow fuel line from tank
99 mazda b3000 where is the speed sensor located
The Mazda B2200 truck body did not change much, if at all between 1986 and 1993. There should be no differences in the shape of the engine compartment. -Kyrasis6 Owner of Mazdatruckin.com
if your truck is carburated your going to have to get a new fuel pump my friend. Taking the bed of your truck is fairly easy. I had to do the same thing for my 1990. The fuel Pump is located in the gas tank on the passanger side of the bed.
It is what the carburetor or fuel injection is mounted to.Plain and simple.Or under the air cleaner assembly.
Below are attached links discussing the horn on your truck.
Get a manual on your truck from DISCOUNTAUTOREPAIRMANUALS.COM They are about $9
The OBD port for a 1992 Mazda B2200 truck is located under the dashboard, near the driver's side. Specifically, you can find it above the brake pedal, close to the steering column. It may be covered by a panel or plastic cover, so you might need to remove that to access the port.
Ummm no where??!!?! for one a b2200 is a Mazda pick up and in that case it would be on the drivers side half way back affixed to the inner side of the frame rail :P simalair location on either truck though
left frame rail between tank and engine
At the top of the clutch pedal in the cab of the truck.