no
The boot lid is held open by the gas struts. One or both of yours is faulty.
The words "Boot Open" means the trunk lid is open. Cheers, Jeff
The words "Boot Open" means the trunk lid is open. Cheers, Jeff
Look under the boot lid and you will find a plastic blanking plate just to the right of centre. Flip this plate out and insert key in the lock that is now exposed. Simple eh!
Heckklappe geht nicht mehr auf = Trunk lid/Boot lid won't open any more
Press on the zero of the 607 motive on the boot lid- IF IT DIDN'T OPEN ,THEN YOU WILL SYNCHRONIZE YOUR KEY REMOTE. start the engine,press the lock on remote for 10seconds,stop the engine,wait for another 10seconds.press open for 5seconds.Then try open your boot with your remote.this should work.
To open the boot on a Peugeot 106, you can either use the key or the interior release lever. If using the key, insert it into the lock on the boot lid and turn it to unlock. Alternatively, pull the boot release lever located in the driver's side footwell to pop the boot open. If the vehicle has a central locking system, ensure it is unlocked first.
If it's the brake light in the boot lid then you have to take the cover off the inside of the boot lid and then you will have access to the light bulbs. If it's the brake light in the rear quarter panel then you open boot lid and unscrew the two bolts holding the light cluster and slide it backwards, then you will have access to the bulbs
To open the boot of a Peugeot 307CC, locate the boot release button, which is usually found on the driver's side near the door or on the key fob. If you have the key fob, press the boot release button to unlock it. Alternatively, you can manually lift the boot lid from the back if it is unlocked. Ensure the vehicle is in the correct position and that there are no obstructions before opening.
in your boot is a switch if you look at the boot when open is a 2 part switch one part in the boot and the other in the boot lid the switch conects when you close the lid on my ka it works the brake lite hi vise boot switch and rear wiper motor very bad designe i had to replace it or make a new wireing loom and do away with the switch hope this helps george
usually its the pressurised telescopic arm on the boot lid needs replacing you are taking the weight of the boot lid with no assistance of the telescopic arm