0
If the auxiliary water pump in your VW Golf GTI VR6 won't turn off, it could be due to a faulty temperature sensor or relay that is incorrectly signaling the pump to stay on. Additionally, there may be a wiring issue causing a short circuit, or the pump itself could be malfunctioning. It's also possible that the engine control unit (ECU) is not receiving accurate data about the engine temperature, leading to continuous operation of the pump. Checking these components can help diagnose the problem.
What else can I help you with?
Should water pump turn over easy?
yes
Can replacing the water pump and serpentine belt in 2004 jeep wrangler make turn signals malfunction?
Replacing the water pump and belt should not affect turn signal operation.
If i have water in my gas in my 95 beretta and it wont start how do i get the water out?
take fuel filter out turn key and let pump pump it out
How can I use a pump to efficiently drain water from my pool?
To efficiently drain water from your pool using a pump, follow these steps: Connect a hose to the pump's outlet and place the other end of the hose where you want the water to drain. Submerge the pump in the pool and turn it on. Make sure the pump is set to the appropriate setting for draining water. Monitor the water level in the pool and adjust the pump as needed to drain the desired amount of water. Turn off the pump once the water has been drained to the desired level.
How can I efficiently pump water out of a pool?
To efficiently pump water out of a pool, you can use a submersible pump or a pool pump with a hose attachment. Place the pump at the lowest point in the pool and connect the hose to a drainage area. Turn on the pump to remove the water quickly and effectively.
How can I change a well pump?
To change a well pump, you will need to first turn off the power to the pump. Then, disconnect the old pump from the water system and remove it from the well. Install the new pump in the well and reconnect it to the water system. Finally, turn the power back on and test the new pump to ensure it is working properly.
What is a recirculation pump?
It is a pump that keeps the domestic hot water circulating back to the hot water tank so that you have hot water quickly when you turn a faucet on.
How can I install a recirculating pump in my home?
To install a recirculating pump in your home, follow these steps: Turn off the water supply to your home. Identify a suitable location near the water heater for the pump. Install the pump on the hot water line, following the manufacturer's instructions. Connect the pump to a power source. Install a check valve to prevent backflow. Turn on the water supply and test the pump to ensure proper operation.
What could be wrong if you are checking for blockage in the lines and pour garden hose water down the pump inlet and water runs down fine but when you try to prime the pump you still get no results?
Check to make sure the basket part of your pump is full of water. If it is an above ground pool an easy way to fill the pump basket and prime the pump is to turn off the pump and set the filter valve to "backwash". Turn pump on and run until water in sightglass runs clear. The pump should have achived primed now. Turn pump off and reset valve to "filter", turn pump on. I do not take off the pump basket lid because the water will come out of it very fast and it is very difficult to replace the lid with all that water gushing up(unless you have shutoff valves or plugs for the lines. I do not have them).
How do you put the word auxiliary in a sentence?
If the main motor fails, the instructions say to turn on the auxiliary motor.
Which way does a water pump on an 1989 ford mustang turn?
counterclockwise
Can a belt not installed properly turn the water pump in reverse?
Maybe.
