yes it will ,its an interference engine meaning that pistons will hit valves bending them.to cure this problem is to either purchase a set of new valves or you can buy a new engine or you can avoid this by just simply have the timing belt change good luck peace.
The Volvo 850 does not have a non-interference engine. This means that if the timing belt breaks, then serious internal engine damage will inevitably occur.
Yes. If the timing belt breaks while the engine is running you will bend the valves and probably damage the pistons.
The 1990 Volvo 740 GLE is equipped with a B230F engine, which is considered a non-interference engine. This means that if the timing belt were to fail, the pistons would not collide with the valves, preventing severe engine damage. Regular maintenance of the timing belt is still crucial to ensure the engine operates smoothly and reliably.
Yes it is and when the timing belt fails with engine running the valves and pistons will collide causing damage.
check all tour belts. it usually means that your timing belt has slipped.
The 2.3 liter and 2.4 liter are interference engines , so probably
Yes, the Volvo S70 is equipped with an interference engine. In an interference engine, the pistons and valves occupy the same space, meaning that if the timing belt fails, the pistons can collide with the open valves, potentially causing significant engine damage. It’s important to maintain the timing belt and replace it at recommended intervals to avoid such issues.
The 2002 Volvo S60 is equipped with a timing belt. It's important to follow the manufacturer's recommended maintenance schedule for timing belt replacement, as failure to do so can lead to engine damage. Always consult the owner's manual or a professional mechanic for specific maintenance guidelines.
To set the timing on a Volvo 240, first, ensure the engine is at operating temperature and then turn off the engine. Locate the timing mark on the crankshaft pulley and the timing pointer on the engine block. Start the engine and use a timing light to check the timing; adjust the distributor as necessary to align the timing mark with the specified degree (usually 12-16 degrees BTDC for the B230F engine). Finally, tighten the distributor hold-down bolt and recheck the timing to ensure it remains accurate.
Yes, the 1999 Volvo S70 has timing marks that are used to properly align the timing belt and ensure the engine's valves and pistons operate in sync. These marks are typically located on the crankshaft and camshaft pulleys, and they play a critical role during timing belt replacement or maintenance. Proper alignment of these marks is essential to avoid engine damage. Always refer to the vehicle's service manual for specific instructions and diagrams.
According to the Gates website ( they make timing belts etcetera ) the 2.4 liter five cylinder engine in a 2006 Volvo S40 ( is NOT an interference engine )
Unless I'm mistaken , if a timing belt goes on ANY car it WILL damage the engine. If you whack the clutch in and stop immediately you may limit the damage. Timing belt change intervals vary. Halfords or eBay haines manual £13 new will tell you what the correct timing belt change intervals are. usually 30-60 K miles depending on make. I would never risk it... unless we're talking old banger. On a US market 960, you will have major damage if your timing belt breaks. The engine is what is called an interference engine. The scheduled replacement interval is 70k. If the last replacement is in question, replace the belt.