Fishing string
To install the air compressor belt on a 1988 Cadillac Brougham, first ensure the engine is off and cool. Loosen the tensioner pulley by turning the adjusting bolt, which will allow you to remove the old belt. Route the new belt around the air compressor pulley and any other pulleys according to the belt routing diagram, then tighten the tensioner back to maintain proper tension on the belt. Finally, double-check the alignment and tension before starting the engine.
you remove the battery hold down brace and voala! its done!
Hi, I have an 1988 Coupe Deville with same issue. Did you ever find out how?
Begin by removing the alternator belt. Remove the wiring harness from the back of your alternator. Remove the alternator retaining bolts. Reverse the process to install your new Cadillac alternator.
In a 1988 Cadillac Brougham, the fuel pump is located inside the fuel tank. To access it, you'll typically need to remove the tank from the vehicle, as it is not externally accessible. Ensure to take necessary safety precautions when working with fuel systems.
To remove the air compressor from a Cadillac, first ensure the engine is off and disconnect the battery. Next, locate the air compressor, typically found near the engine's front, and remove any belts connected to it. Disconnect the electrical connectors and refrigerant lines, ensuring to recover any refrigerant properly. Finally, unbolt the compressor from its mounting bracket and carefully lift it out of the engine bay.
To replace the air ride compressor on a 1999 Cadillac DeVille Concours remove the air shocks located under each wheel and replace it.
To remove the glove box from a 1993 Cadillac Fleetwood Brougham, first open the glove box and locate the screws or fasteners securing it to the dashboard. Remove these screws using a screwdriver. Once the screws are removed, gently pull the glove box towards you to detach it from the hinges. Be cautious of any wiring or clips attached and disconnect them if necessary.
On a 1991 Cadillac Brougham, the horn is typically located behind the front grille, near the radiator support. It is usually mounted on the driver's side, making it accessible for maintenance. To reach it, you may need to remove the grille or other components depending on the specific layout of the vehicle.
To remove the air compressor on a 1995 Cadillac Fleetwood, start by disconnecting the negative battery cable to ensure safety. Then, drain the refrigerant from the AC system using a recovery machine, as it's illegal to vent it to the atmosphere. Next, detach any electrical connectors and remove the serpentine belt from the compressor. Finally, unbolt the compressor from its mounting brackets and carefully lift it out of the engine bay.
assuming it is a Cad GM wire wheel cover, remove the cadillac emblem in the center, you will see a COLOR CODED lock. You will need the proper colored key to remove it. Good luck