Yes, a universal joint is a type of lower pair joint that allows for rotational motion between two shafts that are not in line with each other.
1 higher pair can replace 2 lower pair.
If it is ball bearing, it is of higher pair. since the balls in the bearing have point contact with the surface. if it is a journal bearing, it is of lower pair. since the jounal is having surface contact with the shaft. This question refers to the type of pairs in a mechanical joint...
Yes, in poker, a higher pair always beats a lower pair.
It is a two pronged fork used to get pickles out of a jar. In vehicle maintenance it is the nickname for a ball joint separator, also a two pronged tool that gets larger as it goes back from the tip of the forks. You put it on the ball joint and drive it in with a hammer to separate the ball joint from the arm.
you need a pickle fork. use a this and a hammer to wedge the ball joint away from the control arm.
u need a big tuning fork and a sledge hammer i did it yesterday
The pickle fork will have to be wide enough to slide around the tripod joint housing. Hold it at 45 degrees and give it a good solid whack. Hard enough whack to dislodge the C clip holding it in. Hope this helps
The sternocleidomastoid pair and the splenius capitus pair act to rotate the head around the joint between the axis and the atlas.The sternocleidomastoid pair and the splenius capitus pair act to rotate the head around the joint between the axis and the atlas.
The easiest way to find out if your gammon is thoroughly cooked is to poke it with a fork. If the fork inserts easily into the meat and the juices run clear, it is properly cooked.
No, in poker, 3 of a kind is higher than 2 pair.
No, in poker, 3 of a kind is higher than two pair.