answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What Allison transmissions were coupled up to the cat 3208?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What size bell housing on a cat 3208 engine?

The Cat 3208 is an "SAE #2" size. Refer to your transmissions SAE size.


How much does cat 3208 weight?

2000 pounds


How much torque does a cat 3208 engine have?

A CAT 3208 engine has between 210 and 435 HP. The exact HP will depend upon the exact version of engine that you have. This is a diesel engine that was first produced in the year of 1975.


What does a wix 33370 fuel filter fit?

3208 cat in 1988 elite motorhome


What nicknames does Allison Iraheta go by?

Allison Iraheta goes by Allie, and Allie Cat.


How do you adjust valve lash for a 3208 cat diesel engine?

how adjust the valves


Where can you find a shop manual for a 3208 Cat marine engine?

Have you tried contacting CAT perhaps they could better answer your Question. http://www.cat.com/cda/layout?m=37391&x=7 Hope this Helps.


Where is the range inhibit on a 1000 Allison transmission?

2006 blue bird cat engine,allison transmission has range inhibit and no shift


How do you tell if my cat has a toothache?

Excessive saliva coupled with loss of appetite would be an indication.


What is the unloaded weight of a 1999 kenworth t800 dump truck?

When I drove for Pioneer Sand, our T800 tandems with steel dirt tubs, C10 Cat engines, and 10 OD transmissions weighed in around 23,000. With the steel rock tubs, C11 Cat engines, and 10 OF transmissions, they scaled about 1,000 lbs. heavier.


Where can you find information about Volvo tractor trailer trucks and their shift pattern the rpm's used to shift and also about their power shifter?

You would do better by searching on "Allison transmissions" or Eaton transmissions" or "Fuller transmissions". Maybe "Cat motors" or "Detroit Series 60 engines". The things you want to know have nothing to do with the brand of truck but with the motor and transmission and rear end.new answerthe information u need is available thru Volvo dealers mack trucks are now the Volvo dealers thru out the usathey will need last 6 numbers of your vin number to know what transmission you have, to give you the right informationI met a driver today who has a Volvo VN tractor with a 10-speed transmission, and asked him this.His truck uses an Eaton Fuller 10-speed manual, and the shift pattern on it is the same as any other Eaton Fuller 10 speed: reverse is up and to the left, 5th is down and to the right, and there's a two-speed rear axle with a splitter on it.He uses progressive shifting on his tractor: he shifts at 1100rpm from 1st to 2nd, 1400rpm to shift from 9th to 10th, and tries to space out the other shift points somewhat evenly.To get information about the Volvo iShift transmission, contact Volvo.As the above answer stated call a Volvo dealer with the last 6 of vin. Get them to send you the build sheet for your truck. Every truck is specified different from motor to trans to rear end gear. No 2 are exactly the same unless they were all built for the same company and at the same time using the same build sheet or spec sheet.


How hard would it be to convert a 1993 Ford F700 7.0EFI gas engine to a 3208 caterpillar diesel engine?

pretty difficult but you would have a much better truck when it was done. is your gas engine a 7.5 v-8 (460) if so the transmission will need replaced too. the cat will have an s.a.e bolt pattern don't know which one. then you will need new mounts and the other thing is the rear axle gears will be to low, because of the difference in top rpms and available torque. better off to sell truck and buy another. i have a 3208 turbo for sale if you still want to proceed. 541 990 3969 Oregon