A CAT 3208 engine has between 210 and 435 HP. The exact HP will depend upon the exact version of engine that you have. This is a diesel engine that was first produced in the year of 1975.
The torque specifications for an injector, on a Caterpillar see nine diesel engine, is seven pounds. Over torque in the injector can ruin it.
The Caterpillar C15 diesel engine torque specifications for the rod bearings is 35 pounds. The main bearing torque specifications is 350 pounds.
The head bolt torque specifications, for a Caterpillar 3024 diesel engine, is 170 pounds per square inch. The bolts should be tighten at 50 pound intervals.
The torque specifications fourth the rocker arms, on your C 15 Caterpillar diesel engine, is 14 pounds per square inch. The rocker arm should be torqued at seven pound intervals.
4.7 liter per/hour
The Cat 3208 is an "SAE #2" size. Refer to your transmissions SAE size.
2000 pounds
how adjust the valves
i need rocker arm torque for 3176 cat
Any CAT dealer can look it up,I work for a Cat dealer,the torque is 75 ft lbs
Have you tried contacting CAT perhaps they could better answer your Question. http://www.cat.com/cda/layout?m=37391&x=7 Hope this Helps.
pretty difficult but you would have a much better truck when it was done. is your gas engine a 7.5 v-8 (460) if so the transmission will need replaced too. the cat will have an s.a.e bolt pattern don't know which one. then you will need new mounts and the other thing is the rear axle gears will be to low, because of the difference in top rpms and available torque. better off to sell truck and buy another. i have a 3208 turbo for sale if you still want to proceed. 541 990 3969 Oregon
A C15 Caterpillar engine has dozens of torque specifications for many different engine bolts. The head bolts should be torqued at 350 pounds.
3208 cat in 1988 elite motorhome
29 ft.-lbs.
The torque specifications for an injector, on a Caterpillar see nine diesel engine, is seven pounds. Over torque in the injector can ruin it.
The Caterpillar C15 diesel engine torque specifications for the rod bearings is 35 pounds. The main bearing torque specifications is 350 pounds.