answersLogoWhite

0


Best Answer

the technical name for a tranformer formed by other TFs combining is a gestalt. Informally, they're known as combiners. These include Devastator, Bruticus, Menasor (Decepticons), and Superion, Defensor, Computron (Autobots)

the one that starred in ROTF (The big multi-colored guy that ate half a pyramind) is the new version of Devastator. I didn't care for him much, but oh well.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the Name of transformer made from several transformers?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about General Arts & Entertainment
Related questions

Why ac current is used in a transformer?

AC current or DC current can be used in transformers. A transformer is made of two coils of wire, the input coil induces a current into the output coil. Transformers change the voltage either up (step up transformer) or down (step down transformer). The amount of change in voltage is dependent solely on the number of windings in both coils in the transformer. DC transformers work exactly the same way AC transformers do.


What is transformer ducts?

The transformer ducts are usually made up of strips of transformer board that is glued to the Diamond patter resin coated paper. It is widely used by transformers for manufacturing oil immersed distribution transformer windings.


What is the need of high frequency transformers?

High-frequency transformers could be transformers operating at frequencies higher than 50 or 60 Hz. An example is the transformers used in transport aircraft power supplies which operate at 400 Hz. This allows a transformer with a given power rating to made made with one eighth the mass of an equivalent transformer for a 50 Hz supply. Another type of high-frequency transformer is the tuned transformers used in radio systems. A tuned transformer passes signals over only a limited band of frequencies so is useful in radio receivers to tune out unwanted signals on different frequencies from the one that is needed.


How many transformer movies were made?

Three. Actually two but there making a new one about Apollo eleven going to the moon and finding time traveling transformers.


What is one to one transformer?

Transformers are very versatile devices. The basic concept of energy transfer between mutual inductors is useful enough between a single primary and single secondary coil, but transformers don't have to be made with just two sets of windings.A 1:1 transformer has the same number of windings on the primary as on the secondary. This means that voltage in = voltageout and the transformer can be used as an isolation transformer.


Why should you not use a transformer made for a clothes dryer for an answering machine?

Clothes driers do not use transformers, the motor runs at the line voltage.


Why transformers were made?

A transformer is an electrical device that takes electricity of one voltage and changes it into another voltage. You'll see transformers at the top of utility poles and even changing the voltage in a toy train set.A transformer changes electricity from high to low voltage using two properties of electricity.


State three reasons for the widespread use of transformer?

The three main reasons for the widespread use of transformer are power outage, more power supply and sustainability among consumers. This is what has made the transformers to be much appreciated.


Is there going to be transformer 5?

I don't believe there are plans for a fifth Transformers movie at this time, so it's hard to say whether or not one will be made.


How are baby transformers made?

well, the mecanical sperm and macanical egg in the transformer (male and female), well they have to connect in private. its a lot like the human version.


Who made transformers animated?

hasbro has made transformers animated


When where transformer the show made and by who?

The Transformers aired from 1984-1987. It was written in the United States but was animated in Japan. It was created in collaboration with the Hasbro Toy Company and a Japanese toy manufacturer, Takara.