yes..but you would have to completely clean the entire unit after you are done and flush it out completely then replace the swamp cooler pads with new ones as CLR is very bad for your health. Using scrub brush is better but harder work.
use CLR or anything with oxi clean, kaboom works pretty well.
Yes, CLR (Calcium, Lime, and Rust remover) can be used to clean house windows, particularly to remove mineral deposits and hard water stains. However, it's essential to dilute it according to the manufacturer's instructions and avoid prolonged contact with glass and frames, as it can damage some surfaces. Always test a small area first and use protective gear, including gloves and goggles, to ensure safety.
Cleaning soap scum off of a glass shower door can proove to be very difficult. This is due to the fact that soap scum can easily build up and become very resilent to removal. The best product to clean this soap scum is the product CLR.
Try removing and cleaning out the aerator on the sink faucet, and the shower head. (Word to the wise: if you take them apart, write down the order. It can be tricky trying to figure it out, afterwards). By just removing them, you should get hot water, thereby verifying that these are the cause of the problem. If you don't want to clean them, you can always replace them. Water saving aerators are available for faucets. Water saving shower heads are also available. Some shower heads even have on and off switches, for additional water savings. How I learned, the hard way: My situation was, hot water from kitchen & bathroom sink faucets, and even from the tub faucet, but not from the shower head. So, I removed the shower head and soaked overnight in CLR.* Cautionary note: Probably would have been OK to soak overnight in vinegar, or for a few hours in CLR. But overnight was too long in CLR. It must have dissolved more than just the calcium deposits. Now the shower head has much thicker and much more water consuming streams. (Previously it had a very stingy water conserving spray).
The best soap scum remover often depends on personal preference and the specific surfaces being cleaned. Popular options include commercial products like Zep Shower, Tub and Tile Cleaner or CLR Bath & Kitchen Cleaner, which are effective at dissolving soap scum. For a more natural approach, a mixture of vinegar and baking soda can work well, as the acidity of vinegar helps break down the buildup. Always test any cleaner on a small area first to ensure compatibility with your surfaces.
It's not recommended to use CLR in a dishwasher as it can leave behind chemical residues that may be harmful if ingested. It's better to use dishwasher-specific cleaners or vinegar for cleaning and descaling your dishwasher.
yes
NO! CLP, yes. CLR is a strong acid that is meant for cleaning toilets and sinks. It will corrode a gun.
Use CLR and a scrub brush
CLR cleaner is not recommended for use on nickel as it can cause damage to the finish. It is best to use a cleaner specifically designed for nickel surfaces to ensure it remains safe and undamaged.
To use CLR (Calcium, Lime, and Rust Remover) in coffee makers, first dilute the CLR solution with equal parts water according to the manufacturer's instructions. Pour the mixture into the water reservoir of the coffee maker. Run a brew cycle without coffee grounds, and then follow up with several cycles of plain water to thoroughly rinse out any remaining CLR. Always check your coffee maker's user manual before using CLR, as some manufacturers may advise against it.
This is not a recommended use for CLR. People have done this and report no adverse result's, but I would not.
Honestly? No need to bother - just get some CLR and use that.
soak it in CLR for awhile, then use an old toothbrush to scrub off the lime you can get CLR at any grocery store, in the laundry soap aisle
Personally, I wouldn't recommend using CLR in the dishwasher unless you live in an area with extremely hard water and don't have a water softener. If this is the case, Jelmar (the manufacturer of CLR) recommends using 1/2 cup CLR once the empty dishwasher is at least half filled with water.
CLR is a common choice for cleaning mineral deposits in household appliances, but it is not recommended for use in steam irons. The chemicals in CLR can be harsh and may damage the internal components of the iron. It is best to use a mixture of water and vinegar or a specifically formulated iron cleaner to clean the reservoir of a steam iron.
It depends exactly what is in that well water, but generally I find CLR works very effectively .It depends exactly what is in that well water, but generally I find CLR works very effectively .