0
What else can I help you with?
What's the difference between a front load washer and a normal washer?
The difference between a front load washer and regular washer is that a front load washer has a door in front were clothes are loaded and that is also where washer settings are located. The regular washer is usually a top load where clothes are loaded on top of the washer.
WHAT IS THE CUBIC FEET OF MY MAYTAG WASHER MODEL?
maytag washer model mtw5800two
Can you use regular detergent in a high efficient washer?
Nope itll ruin the washer!! And itll start to smoke....happened to me and i had to buy a brand new washer :(
What Temperature on washer warm setting?
That will depend on the make of the washer. Warm is usually 30-40 degrees Celsius.
What is the Summary of the village washer?
How is the conflict resolved?
Washer fluid level sensor 2001 villager?
The 2001 Villager washer fluid level sensor is inside of the washer fluid reservoir. The sensor can be access through the bottom of the washer fluid reservoir.
Where is winshield washer low quantity sensor?
The sensor is inside the water bottle
How do you rest low washer light on 2005 Dodge Dakota?
All you need to do is add washer fluid. If the light is still on, the sensor or wiring have failed.All you need to do is add washer fluid. If the light is still on, the sensor or wiring have failed.
Washer or dryer cause shrinkage cause color loss?
color loss, washer, always was on cold for color fastness. shrinkage is dryer, you can avoid this by using low heat or no heat tumble dry
Is the sensor for windshield washer fluid part of a kit?
NO!
How do you turn off windshield washer light on civic?
Fill washer resevoir - if it does not shut off possiby a bad sensor
How do i turn off 2006 Dodge Sprinter washer fluid level warning light?
Fill the washer fluid or repair the level sensor in the washer fluid bottle.
How do you replace the washer fluid sensor on a 3000GT?
To replace the washer fluid sensor on a Mitsubishi 3000GT, first, ensure the vehicle is turned off and the battery is disconnected for safety. Locate the washer fluid reservoir, typically found near the front of the engine bay. Remove the connector from the sensor, unscrew or unclip the old sensor from the reservoir, and install the new sensor by reversing the removal process. Finally, reconnect the battery and check the system to ensure the new sensor is functioning properly.
My Nissan Frontier washer fluid sensor dash light will not reset How do I get it to reset?
There is a magnetic float inside the washer fluid tank that causes a magnetic sensor on the outside of the tank to activate when the fluid is low. Either the sensor is bad or the float is stuck.
Where is the water sensor for a 88 Bonneville?
If you mean the low coolant sensor, it is located on the radiator about 3-4 inches below the cap, it screws into the back side of the radiator. There is also a low washer fluid sensor located in the top of the winshield washer reservior.
How do you replace windshield washer water level sensor for a 1993 Mercedes 400 sel?
To replace the windshield washer water level sensor in a 1993 Mercedes 400 SEL, first, ensure the vehicle is turned off and the washer fluid reservoir is accessible. Disconnect the electrical connector from the old sensor, then carefully remove the sensor from the reservoir by twisting or pulling it out, depending on its design. Install the new sensor by inserting it into the reservoir and reconnecting the electrical connector. Finally, test the system by filling the reservoir and checking the washer warning indicator on the dashboard.
Why does my 01 jeep grand Cherokee tell you the washer fluid is low even after you refill the tank?
The washer fluid sensor is probably bad.
